AD18BEDMAT

DECKED AD18BEDMAT, 9989 Installation guide

  • Hello! I've read the user manual for the Bed Mat, and I'm ready to help you with any questions you might have. The manual provides details on how to install the mat, including whether to trim it based on your bed size, the required tools and how to use the trimmed piece as a drawer liner.
  • What tools are needed for installation?
    Do I need to cut the mat?
    What should I do with the trimmed piece?
THESE MIGHT BE USEFUL: Watch installation videos at www.DECKED.com/video or scan here:
HOW TO: Battle Mat INSTALLATION
If you have a 6'4" - 6'9" bed, there is no need to trim the Battle Mat.
Simply place the mat on top of your DECKED drawer system, center it, and
keep on truckin'.
STEP 2: TRIM BED MAT FOR SHORT BEDS
The Bed Mat will need to be trimmed for 5'5" - 5'9" beds.
Locate the recessed cutting lines marked on the tailgate end of the Battle Mat.
Use a SHARP utility knife.
Don't be a hero - use at least three gentle but firm passes to cut through the
Battle Mat - see detail in red below.
No waste! You can use the trimmed off piece as a drawer liner.
@DECKEDUSA | #DECKEDUSA
DECKED.COM | 208.806.0251
UTILITY KNIFE
STRAIGHT EDGE
TOOLS NEEDED:
STEP 1 : CONFIRM BED LENGTH
NOTE: NO FASTENERS NEEDED. THE 1.25" SCREWS INCLUDED ARE TO BE USED FOR
INSTALLING CORE TRAX ON TOP OF THE BED MAT. SAVE THESE FOR FUTURE USE.
/