EN-5
CD-Rewritables,Do not try to play CD-ROM,
CDi,VCD,DVD or computer CD.
Insert a MP3/CD or CD-R with the printed
side facing up and press CD OPEN/CLOSE
button to close the CD door.
The SY-8035 can play Audio Discs,MP3 CD-R、
To open the CD door, press CD OPEN/CLOSE
button.
-the CD/MP3 has reached to its end.
CD/MP3 PLAYER
Playing a CD/MP3
1.Press & hold down continously.
The disc will forward or rewind at higher
speed!
During this proccess there will be no sound until
you release the button
2>Playing tracks in Repeat mode having pressed
Repeat button twice,The
display will appear as below:
/Random
3>P
Repeat/Random button thrice,The
display will appear as below:
laying tracks in Repeat mode having pressed
1>Playing tracks in Repeat mode after having
pressed the Repeat/Random button once.The
display will appear as below:
MP3
PLAY
REP.
MP3
PLAY
REP. ALL
MP3
PLAY
REP. ALL
ALB UM
5>When the Repeat/Random button is pressed
five times,the Random indicator light goes
off The unit returns to normal mode.
The display will appear as below:
4>When the Repeat/Random button is pressed
four times,the Repeat indicator light goes off
And the Random mode is activated.The
display will appear as below:
Different play modes:
Repeat/Random
Repeat-Plays the current track continuously.
Repeat all-Plays the entire CDcontinuously.
MP3
PLAY
MP3
PLAY RAN DO M
3. Press the + 10/ FOL or - 10/ FOL- button on
the remote to the select tracks or folder.
-You can use to select a particular
track.
-The LCD display the current song folder after
5 seconds, The display will not show the folder
if there are no folders.
+
EN-6
-you select the other mode of AUX or RADIO.
Note:
-The display will only show “MP3" when the Fomat
of the file is MP3.
-The display will only show USB when audio files are
being played from the USB.
Radio reception
1. Slide the FUNCTION selector to "RADIO”.
2. Slide the BAND selector to a desired setting -FM STEREO, FM, AM.
3. Rotate the TUNING control to find the desired stations.
NOTE: If the BAND selector is set to the FM stereo station,the FM stereo LED
indicator will light.
Remote control
1. Open the battery cover to remove it.
2. Insert two (AAA) battery ( included) correctly so that the + and - polarities match the polarity
diagrams inside the battery compartment.
Install battery
Note:
* The batteries can last approximately half a year for normal operation.
* When the batteries are exhausted, the remote control will no longer operate the system.
Replace both batteries with new ones.
* When the remote control is not to be use for a long time, remove the batteries to avoid
damage caused by battery leakage and corrosion.
* Avoid keeping the remote control in extremely hot or humid locations.
* Make sure there are no obstacles between the remote control and the sensor of the unit.
The maximum angle permitted is within 30°.
* The remote control operating distancd is about 0.2 meters to 6 meters away from the remote
sensor.
- For a better AM reception , the unit incorporates a built-in antenna which means the visible
antenna is of no use.Direct the whole unit to obtain the best possible signal.
During
playback
you
can
use
or
to
select a particular track in play or pause mode.
· If you have selected a track number in the stop or
pause position, press play/pause to start playback.
· Press once briefly for the next track
Press repeatedly until the desired track number appears
on the display.
· Press
once briefly to return to the beginning of a
current track.
· Press
more than once for a previous track.
2.Connect the power cord to the AC MAINS inlet and the wall outlet. Press the power button
to switch on the unit .
The power supply is now connected and ready for use.
Adjust the source selector to MP3/CD
Press on the set to start playback
To pause playback press .
To resume,
press again.
To stop CD playback,press STOP
-you open the CD comprtment;
Note: CD/MP3 play will also stop when:
Selecting a different track
When you recognize the passage you want
release or
Normal playback resumes.
Using AC Power
1.Check if the power voltage, as shown on the type plate located on the bottom of the set,
corresponds to your local AC power supply. If it does not, consult your dealer or service
centre.
3.To switch off completely, unplug the power cord from the wall outlet.
• Unplug the power cord from the wall outlet to protec your set during heavy thunderstorms.
- For a better FM reception, pull out the unrolling wire antenna
Reduce its length if the signal is too strong (very close to a transmitter).
1.To select your sound source adjust the source selector to MP3/AUX/RADIO
2.Adjust the volume control before playing back and make sure it is low.
When the unit is not in use, make sure the switch power is set to OFF and avoid unneccessary
energy consumption.
Finding a passage within a track
Power Supply
General operation
RADIO