Reznor P6SP 6, 7.5 - 10 Ton Product information

Category
Electrical relays
Type
Product information

This manual is also suitable for

3 Phase 60 Hz.
4. For supply wire ampacities and overcurrent protection, see unit
rating label.
5. On “C” Series Models only. For 208V operation remove wire from
230V tap and place on 208V tap.
1. Couper le courant avant de faire letretien.
2. Employez uniquement des conducteurs en cuivre.
7107540
0209
WIRING DIAGRAM
P6SP-072 (C/D) Series
NOTES:
1. Disconnect all power before servicing.
2. For supply connections use copper conductors only.
3. If any of the original wire as supplied with the unit must be replaced,
it must be replaced with wiring material having a temperature rating of
at least 105C.
CCH - Crankcase Heaters, Stage 1&2 Compressor
CC1&2 - Contactor, Stage 1&2 Compressor
IBC - Contactor, Indoor Blower Motor
OFC - Contactor, Outdoor Fan
T1
T2
T1
T2
T2
T3
T1
IBC
L1
L2
L3
GND
24V Common
24V Hot
Compressor 1
T2
T1
T3
CC1
Aux.
Switch
(N.C.)
CC1
CCH1
IBC
OFC
Y1
Factory
Jumper
LVT-C (24V COM.)
Aux. Switch
(N.O.)
IBC
Field Supplied Disconnect
(3Phase Power Only)
For supply connections use
copper conductors only.
Unit
Terminal
Block
Transformer
24V Sec.
Primary
Outdoor Fan Motor
Outdoor Fan Motor
Indoor Fan Motor
LVT - Low Voltage Terminal
HK - Heater Kit
E - Economizer
- Indicates plug connection.
4 Amp
Circuit
Breaker
See Note 5
OFC
LVT-R
High
Pressure
Switch
Stage 1
Evap.
Freezestat
Low
Pressure
Switch
CC1
HK-4
Blower
Relay
CC1
Aux. Switch
(N.O.)
2
1
3
4
¢710754+¤
LVT-Y1(Stage 1 Cool)
HK-1
HK-2
HK-3
LVT-Y2(Stage 2 Cool)
LVT-G
LVT-W1(Heat)
E-1
E-9
E-8
E-2
E-4
E-5
Y2
Factory
Jumper
208-230/460 Volt
- Indicates screw connection.
  • Page 1 1

Reznor P6SP 6, 7.5 - 10 Ton Product information

Category
Electrical relays
Type
Product information
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI