En-1
AIR CONDITIONER
OPTIONAL PARTS
Terminal block kit for 2-wire remote controller
INSTALLATION MANUAL
For authorized service personnel only.
PART No. 9380828167
1. SAFETY PRECAUTIONS
• Hand this manual to the customer to keep for future use, such as for relocating or repairing the product.
WARNING
Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or
serious injury.
For the air conditioner to operate satisfactorily, install it as outlined in this installation manual.
Installation work must be performed in accordance with national wiring standards by authorized personnel only.
Do not turn on the power until all installation work is complete.
Discharge static electricity before the installation.
CAUTION
Indicates a potentially hazardous situation that may result in minor or moderate injury or damage to
property.
Do not wire the terminal block kit wire together with or parallel to the connection cables, transmission cables, remote controller
cables, bus wire, and power supply cables of the indoor and outdoor units. It may cause erroneous operation.
Do not touch the aluminum n in the indoor unit.
When installing, do not cut or pinch the wires with the front panel or control cover. An electric shock may occur if wires are damaged.
2. ABOUT THE UNIT
This option is to install a wired remote controller to the air conditioner. Before installing, please have the installation manual of
the indoor unit on hand for detailed information.
2.1. Parts and accessories
• The following installation parts are supplied. Use them as required.
Name and shape Qty Description
Installation
manual
1
This manual
Terminal block
(with wire)
1
For connecting the
wired remote control
unit to the indoor unit
main PCB.
Screw (M4x20)
1
For installing the terminal
block to the indoor unit.
Wire with connector
1
For connecting the
communication PCB to
the main PCB.
Name and shape Qty Description
Communication PCB
1
For connecting the
remote controller to the
indoor unit.
EMI core
1
Install for EMC
measures.
Cable tie
1
For x the EMI core
Push mount cable tie
1
For binding the wires.
9380828167-01_IM_En_UTY-TWRXZ3.indd 19380828167-01_IM_En_UTY-TWRXZ3.indd 1 2020/11/05 13:52:302020/11/05 13:52:30
En-2
2.2. Connecting the PCB
Description of Communication PCB
Wire with connector
CN300
CN301
To terminal block
To indoor unit
• Connection depends on the PCB type of the indoor unit. Refer to the installation manual of the indoor unit for details on how to
connect to the indoor unit PCB.
2.3. Connecting cable to control board connector (Floor model only)
Connection number
(P 190)
Hook (L) + Cable (Back)
Hook (L) + Cable (Back)
Control cover
Hook (R) + Cable (Front)
Cable with core
Vinyl tape
Cable (Place along)
Close
Core (large)
Cable tie
(Fix diagonally)
Push mount cable tie
Manufacturer
:
FUJITSU GENERAL LIMITED 3-3-17, Suenaga, Takatsu-ku, Kawasaki, 213-8502, Japan
9380828167-01_IM_En_UTY-TWRXZ3.indd 29380828167-01_IM_En_UTY-TWRXZ3.indd 2 2020/11/05 13:52:302020/11/05 13:52:30
/