Strong SM-RBX-8-WH, SM-RBX-14-WH Template

Hello! I am an AI chatbot trained to assist you with the Strong SM-RBX-8-WH Template. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

THIS MUST BE PRINTED ON AN A3 PAGE (17” W X 11” H) SHEET OF PAPER AT A 1:1 RATIO!

INSTALLATION INSTRUCTIONS

1. Tape this template to the drywall

Center the template between two studs. Make sure that it’s 14” W x 8” H

2. Mark the Location of the holes.

Use a punch or screw to mark holes in each corner.

3. Remove the template and drill the holes

Use an 1/8” or smaller bit, drill through all the holes marked in previous step.

4. Cut the drywall opening

Use a drywall saw to cut between the holes drilled.

Please be sure to check printer settings so no re-sizing occurs.

SM-RBX-8-WH Cutout Template

140529-1014