Strong SM-RBX-14-WH Template

Type
Template

This manual is also suitable for

THIS MUST BE PRINTED ON AN A3 PAGE (17” W X 11” H) SHEET OF PAPER AT A 1:1 RATIO!
INSTALLATION INSTRUCTIONS
1. Tape this template to the drywall
Center the template between two studs. Make sure that it’s 14” W x 8” H
2. Mark the Location of the holes.
Use a punch or screw to mark holes in each corner.
3. Remove the template and drill the holes
Use an 1/8” or smaller bit, drill through all the holes marked in previous step.
4. Cut the drywall opening
Use a drywall saw to cut between the holes drilled.
Please be sure to check printer settings so no re-sizing occurs.
SM-RBX-8-WH Cutout Template
140529-1014
  • Page 1 1

Strong SM-RBX-14-WH Template

Type
Template
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages