Gill LEAD ORBITER INDOOR THROWING WEIGHTS Operating instructions

395030 - ORBITER SPACER KIT

INSTRUCTIONS

01-27-16

INST395030

www.gillathletics.com

800-637-3090

If your Orbiter has stretched beyond the legal length, you

can shorten it by using the spacers (395030) included.

The spacers are two small plastic sleeves.

1. Remove the threaded pin that connects the

swivel to the rings on the harness.

2. Slide the rings of the harness into the swivel

yoke. While re-installing the threaded pin, place

the spacer between the yokes and run the pin

through it. Tighten down the threaded pin.

If the harness stretches further, you can add the

second larger spacer over top of the first spacer.

The spacers effectively increase the diameter of

the threaded pin and shorten the length of the

Orbiter by the wall thickness of the spacer.

WARNING: This product can expose you to Lead, which is

known to the State of California to cause cancer and birth

defects or other reproductive harm. For more information go to

www.p65warnings.ca.gov.