LTGEN3 Instruction Sheet
House Side Shield Installation
AFTER INSTALLATION DELIVER THIS
MANUAL TO OWNER
Figure 2
1 INSTALLATION
1.1 Tools and Materials Required
¼” Socket Driver
1.2 Shields Covered
• Large Teardrop, Bowl, & Flat Glass
House Side Shield
• LTD3HSS90
• LTD3HSS120
• LTD3HSS180
• Large Sag Glass House Side Shield
• LTD3HSG90
• LTD3HSG120
• LTD3HSG180
1.2.2 Loosen wing nut and swing open the outer glass diffuser
and remove. This will now make the COB optical assembly
accessible. See Fig. 1
1.2.3 Attach the shield with provided #10-24 self-threading
screws as shown. See Fig. 2.
1.2.3.1 IMPORTANT: Make certain the shield is NOT installed on
the side indicated as “STREET SIDE”.
1.2.4 Reinstall the glass diffuser assembly in the reverse order as
1.2.1
1.2.5 Return electrical power to luminaire.
Figure 1
GR2497
IMPORTANT SAFETY INSTRUCTIONS
WARNING – READ THESE INSTRUCTIONS
CAREFULLY BEFORE ATTEMPTING TO INSTALL OR
MAINTAIN THIS FIXTURE. WORK MUST BE DONE BY
QUALIFIED PERSONNEL. ALLWAYS DISCONECT
POWER BEFORE SERVICING THE LUMINAIRE
FAILURE TO FOLLOW THESE WARNINGS MAY RESULT
IN DEATH, INJURY OR SIGNIFICANT PROPERTY
DAMAGE.
-
1
HOLOPHANE ESL3 Pendant Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI