2. Evelo
  3. Omega Belt Tension Adjustment Bike

Evelo Omega Belt Tension Adjustment Bike User guide

  • Hello! I am an AI chatbot trained to assist you with the Evelo Omega Belt Tension Adjustment Bike User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Omega Belt Tension Adjustment
This guide shows how to adjust the belt tension on your
EVELO Omega
Questions? Get In Touch:
877-991-7272
contact@evelo.com
Omega Belt Tension Adjustment 2
Sliding Dropouts:
Your Omega uses adjustable sliding
dropouts to set the belt tension. This
system allows you to remove and reinstall
the wheel without needing to adjust the
tension aerward.
Step 1:
Using a 5mm allen wrench, loosen the 2
dropout mounting bolts on each side of
the bike.
Omega Belt Tension Adjustment 3
Step 2:
There is a bolt for adjusting the tension on
each side of the bike, right above the axle
nut. It is mostly hidden, and can only be
seen and accessed from the rear.
Using a 4mm allen wrench, adjust the
bolts on each side to set your desired
tension. Turn the wrench clockwise to
increase belt tension. Turn the wrench
counter-clockwise to decrease belt
tension.
Please be sure to turn the bolt on each
side the same amount to ensure the wheel
stays centered.
Step 3:
Using a 5mm allen wrench, tighten the 2
dropout mounting bolts on each side of
the bike.
Go ride your bike!
There are lots of tools available to set the tension on the Gates Belt, but we can’t
recommend any of them. We’ve found that we get better results just by setting it up
like a chain. In general, looser is better, so long as the belt isn’t skipping. We like to see
1/2” of deflection in both directions at the middle of the belt when pressed lightly. (1”
total deflection)
Omega Belt Tension Adjustment 4
Questions? Get In Touch:
EVELO.COM
First Edition
877-991-7272
contact@evelo.com
/