OKI ES9465 Procedure For The Installation

Brand: OKI

Model: ES9465

Type: Procedure For The Installation

Procedure for the Installation of the

RADF Paper Feed Maintenance Kit

ES9465/ES9475 MFP

Step 1

Unit Disassembly, Part Replacement

Step 2

PM Counter Reset

PN: 45735719

DF-KIT-3018

KIT: PERIODICAL MAINTENANCE

DF-KIT-3018

Pick up roller

ASYS-ROL-FEED

Feed roller

ASYS-ROL-FEED

Separation roller

ASYS-ROL-RET

Step 1 – Unit Disassembly, Part Replacement

Open the jam access cover. Remove

2 screws and take off the bracket.

Remove 1 clip and slide 2

bushings.

Be careful not to drop the

pin because it will come

off when the shaft is

pulled out.

Remove 4 screws and take off the

bypass upper guide.

Take off the paper feeder unit.

Remove 1 clip and pull out the shaft. Take off

the pickup roller and replace it.

Remove the clip, pull out the

shaft and take off the feed roller.

Replace the roller.

Remove 2 screws. Slide the

feeder upper

Make sure you

assemble the

pickup roller with

the one-way

clutch in the

correct direction.

Remove 2 screws and take off the

separation roller holder and

separation roller unit.

Remove 1 bushing and clip, and then

take off the separation roller.

PM Part

Make sure you assemble the feed roller

with the one-way clutch in the correct

direction.

PM Part

Step 2 - PM Counter Reset

(1)Enter PM Support Mode

Enter Service Mode [6]+[START]+[POWER]ON

(2)Authentication screen

If a service password has been registered enter the service password and select “OK”. If a service password

has NOT been registered leave password blank and select “OK”.

(3)Use the page down to go to page 3 of 4. Highlight “RADF” and select “RESET”.

(4)Select “INITIALIZE”.

(5) Once completed turn the main power switch OFF/ON.

This function resets:

• Pick up Roller

• Feed Roller

• Separation Roller

OKI ES9465 Procedure For The Installation

OKI ES9465 Procedure For The Installation

OKI ES9465 Procedure For The Installation

Related papers

Other documents