12
www.comfortel.com.au
CLEANING AND MAINTENANCE
AFTER EVERY CLIENT, THE PEDICURE SPA FOOT BATH
MUST BE CLEANED AND DISINFECTED AS FOLLOWS:
FOOT BATH
1. All Pedicure Spas come with a Spa Giene starter pack. Pour
20ml of undiluted Spa Giene solution into the water. Spa
Giene is an approved Spa cleaner and disinfectant. It will
remove oily product residues, break down biological wastes
(skin cells, oils etc) and disinfect the foot bath and pipes
of the spa to stop cross-contamination and the spread of
infections. Fill pedicure spa foot bath with water to cover jets.
2. Push the ON/OFF button to start the jets working. Allow the
jets to run for 2 minutes, then push the ON/OFF button again
to stop the jets.
3. Drain the water out and then rell with clean water.
4. Start the jets again so the clean water will ush any cleaning
product out of the jets and pipes. Run the jets for 2 minutes,
then stop.
5. Drain the water out.
6. Spray the inside of the Spa with diluted (1:4 dilution) Spa
Giene trigger .
7. Use the hand held shower and a cloth or sponge to rinse any
residue out of the tub.
8. Wipe the inside of the foot bath clean with a non-abrasive
cloth (eg cloth or sponge) and dry all surfaces thoroughly.
9. The chair, foot-rest and surrounding surfaces may be wiped
clean with a so cloth and mild non-abrasive surface
cleaning agent.
WARNING
NEVER USE ACETONE, FURNITURE POLISHES, BLEACH,
DETERGENT, ABRASIVE CLEANERS, STEEL WOOL OR
PRODUCTS CONTAINING PHENOXYETHANOL ON VINYL.
NEVER LEAVE CHEMICALS IN THE BASIN OVERNIgHT.
CLEANING AND MAINTENANCE
ALWAYS FOLLOW THE CLEANING INSTRUCTIONS
• Clean regularly (weekly) to remove body oils which cause
hardening
• To clean use a sponge which has been moistened in warm
soapy water
• Aer cleaning with a sponge, dry with a so, clean cloth
• Stubborn grime may require gentle scrubbing with a so
brush
VINY
Aer every client, the vinyl must be cleaned.
All upholstery needs some care; good housekeeping will help to
prolong the life of any upholstered products.
Avoid extreme temperatures. Extreme cold can make your vinyl
prone to cracking, while extreme heat can cause permanent
stretching.
Avoid exposing your products to direct sunlight for prolonged
periods of time.
MAINTENANCE
A periodic inspection of all components and fasteners should
be made to ensure that your washlounge is structurally intact
and functioning properly. Damaged and broken parts should
be replaced and loose fasteners tightened.
All maintenance to be carried out by a suitably qualied
tradesperson.
PLEASE RETAIN THIS INFORMATION FOR FUTURE REFERENCE.
For more information about our products and services, visit our
showroom or to contact us visit us at
www.comfortel.com.au.
Please note: your warranty does not cover wrinkling, creasing, soiling, fading,
pulls, tears or cuts. Fair wear and tear is not covered by your warranty.