C. Crane WiFi Hotspot Repeater Quick start guide

Brand
C. Crane
Model
WiFi Hotspot Repeater
Type
Quick start guide
WiFi Hotspot Repeater Quick Start Guide
C
D
Enter “admin” for the username and “admin” again for the
password. Press “Log In”.
E
Click on the “Easy Setup” tab in the gray bar.
F
Click the dot next to “USB Wireless Adapter”.
2
Continued
1
WiFi Hotspot Repeater Setup Guide
2Plug in a Compatable
USB Antenna*
3Connect Power
1
WiFi Hotspot
Repeater
*You must follow these instructions carefully.
*
A
AC Power
Adapter
Please Note: The USB Antenna Startup Guide &
Installation are not needed to setup the Hotspot.
Open your Internet Browser screen and enter “192.168.2.1”
into the Address Bar. Press “Enter” on your keyboard.
Attach
Antenna
First
Main USB
Cable
Leave
Unplugged
Super USB WiFi
Antenna 3
Versa WiFi USB
Adapter 3
*Compatable
USB Antennas
NOTE:
Although the WiFi Hotspot Repeater can be setup
from a Tablet or Smartphone, it is much easier to
use a computer and the supplied Ethernet cable to
Connect to the WiFi
Network named “ALFA_AP” from your WiFi
Network list.
-OR-
Cable: Connect the Ethernet cable between
your computer and the WiFi Hotspot Repeater.
Use the Ethernet port that is closest to your
power connection.
B
CC X Mile
Long Range
CC X Mile Omni
WiFi Hotspot Repeater Quick Start Guide WiFi Hotspot Repeater Quick Start Guide
J
Now you will choose an easy name to call your new WiFi
Network. (Example: “BobsNetwork”). Enter it into the
“SSID Choice” Do not use the same name as the network
you are repeating.
If you cannot access the Setup Screen then you may need to
perform a factory reset. To do this, press the red button on the
bottom for at least 5 seconds while it is powered ON. You may
need to use a toothpick or paperclip to reach it. Allow 30 seconds
for the hotspot to reset and startup before attempting setup again.
Reset Button
Bottom Panel
TROUBLESHOOTING
3
Click on “Site Survey”.
G
Scroll towards the bottom of the page. 1. Click the dot
next to the WiFi Network that you want to repeat, then
2. Click “Select”. Note: For best performance, “signal”
H
I
1. If your selected Network requires a password, then enter
it into the space marked “Pass Phrase” *. Do not change
any other settings. 2. Click on the “Next” button.
1
4
* If the security mode is WEP, then enter password into
“WEP Key 1”.
2
1
Congratulations, your new Network is ready to use !
Connect to it from the WiFi Network list on your device.
Look for the name that you entered in step
J
and enter the Password that you entered in step K
1. Choose “WPA-PSK_WPA2-PSK” from the “Security Mode”
dropdown. 2. Choose “Auto (TKIP/AES)” 3. Now create a
wireless password and enter it into the “Pass Phrase”
You must choose a password that contains between 8 and 64
characters. 4. Click on the “Done”
K
1
3
4
2
2
Copyright ©2015 C. Crane All Rights Reserved
must be greater than 30/100.
Please wait for up to one minute.
  • Page 1 1
  • Page 2 2

C. Crane WiFi Hotspot Repeater Quick start guide

Brand
C. Crane
Model
WiFi Hotspot Repeater
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents