DATA SHEET
Cool-stack I
Features
? 1 RU high
? Thermal switch included; can also take 12 volt trigger signal
? Extremely low noise
? 1 year parts and labor warranty
Use an exhaust Cool-stack I at the top of a rack and vent panels below heat-
generating components to exhaust heated air from moderate heat loads. For
larger heat loads, add an intake version at the bottom of the rack to bring fresh
air in.
Specifications
Parameter Value Units
Air Flow 40 CFM
Noise level 21 dBA
Dimensions 1.75H x 19W x 8D Inches
4.5H x 48.3W x 20.3D cm
Power consumption 7 Watts
Weight 8/3.7 Lbs/kg
Part number 00-301-02 Exhaust version
00-302-01 Intake version
Cool-stack and the ATM logo are registered trademarks of Active Thermal Management. All features and
specifications subject to change without notice.
25570 Rye Canyon Rd., Valencia, CA 91355 (661) 294-7999; -1115 (f)
www.activethermal.com
General Description
A one rack-unit high cooler suitable
for moderate heat loads. Available
in exhaust or intake versions; both
include a 90° thermal switch, or can
accept a 12 volt trigger signal.
Exhausts heated air or takes fresh
air in through front panel. Extremely
quiet.
/
