Big Game Treestands TS96-VS User manual

TREE SEAT

ASSEMBLY & INSTALLATION

CR91169

Ultimate Swivel

TS96-VS

Slimline

PO Box 382 • 1820 N. Redding Avenue • Windom, MN 56101

Toll Free: 800-268-5077 • Website: www.biggametreestands.com

WARNING: Tree Seats are to be used at a height that allows the feet to be on

the ground at all times when in use. Use as a ground seat only! Failure to follow

this warning may result in serious injury or death!

Figure 1 Figure 2

CR91169 ASSEMBLY

INSTRUCTIONS:

1. Remove 2" nut, bolt, and

washers from the mainframe.

2. Making sure the strap is facing

inward (toward the seat),

insert post into grove on

mainframe.

3. Reinsert bolt, washers and

nut. Tighten securely.

INSTALLATION - ALL SEATS:

1. Position seat in closed position (see fig. 1).

2. Place strap around tree (see fig. 1).

3. Place buckle over S-hook (see fig. 2).

4. Pull strap through slide buckle until tight.

5. Lower seat into sitting position (see fig. 2).

6. If seat becomes loose, lift seat upright and

retighten strap.

TO REMOVE:

1. Lift seat to upright position.

2. Loosen by sliding strap back through buckle.

3. Remove seat from tree.