National Public Seating DY82 User manual

  • Hello! I am an AI chatbot trained to assist you with the National Public Seating DY82 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Assembly Instructions
DY82 CHAIR DOLLY
FOR 8200 MELODY CHAIR
Mailing Address: 149 Entin Road, Clif
ton NJ 07014
| T
el 800-261-4112 | Fax 973-594-1500
PL
ANTS IN | CLIFTON, NJ 07014 | MEMPHIS, TN 38106 | CHINO, CA 91710
Dear Customer,
T
hank y
ou for y
our pur
chas
e.
Although extreme care goes into manufacturing
& packag
i
n
g of th
is pr
oduct, mistakes are possible. If you encounter any
m
issing parts or difficulty in assembly, etc. please call our customer service —
TOLL FREE at 1-800-261-4112 for courteous & immediate resolution to
your problem.
CAUTION!
Double-check that all screws are tightened securely before
use
.
Failure to completely tighten the screws may result
in tipping & possible injury! Recheck all screws periodically.
P
ARTS & HARDWARE
One Inner Rack
One Outer Rack (with crossbars)
Bottom frame
Four casters (two swivel & two non-swivel)
(16) 7/8" cap-screws (A)
(4) 1-1/2" cap-screws (B)
(2) 2-1/4" cap-screws (C)
(22) lock nuts
TOOLS NEEDED:
1/2” Combination Wrench, Ratchet with a 1/2" Socket
STEP 1.
Install the two non-swivel casters at one end of the frame, using
four (A) caps-screws and lock nuts in each.
STEP 2.
Install the two swivel casters at the other end of the frame, using
four (A) cap-screws and lock nuts in each.
STEP 3.
Starting at the end of the unit with swivel casters, attach the Outer
Rack to the inside of the caster support frame (see picture 1)
using two (B) cap-screws and lock nuts.
STEP 4.
Attach the Inner Rack to the outside of the caster support frame
(see picture 1) at the end of the unit with the non-swivel casters,
usi
n
g two (B) cap-screws and nuts.
STEP 5.
Insert the Inner Rack in between the two lower crossbars on the
Outer Rack (see picture 2). After aligning the holes on both racks,
use two (C) cap-screws and lock nuts to attach.
PICTURE 1
STEP 3
Attach Outer Rack to
inside of caster
support frame
STEP 4
Attach Inner Rack to outside of
caster support frame
PICTU
RE 2
Ins
e
r
t the i
nsi
d
e rack in between the two
lo
we
r cr
ossbar
s on the ou
te
r rack
Inner Rack
Attachment
Outer Rack
A
ttachment
10/30/2006
OUTSIDE RACK
INSIDE RACK
/