45
INSTRUCTIONS FOR USE
DESCRIPTION OF THE REFRIGERATOR
SAFETY WARNINGS
SAFEGUARDING THE ENVIRONMENT
INSTALLATION
USING THE APPLIANCE
MAINTENANCE
AFTER-SALES SERVICE
ELECTRICAL CONNECTION
6gb33014.fm Page 45 Wednesday, October 9, 2002 12:05 PM
46
Thank you for buying our refrigerator. To get the
most of your new appliance, please read this
manual carefully. It contains a description of your
appliance as well as useful tips and safety
warnings.
We are certain that you will enjoy the outstanding
long life and reliability of our product.
DESCRIPTION OF THE REFRIGERATOR
The refrigerator compartment of your new appliance is designed for
storing fresh food and the freezer compartment (if provided) for
storing frozen food and freezing small amounts of fresh food. The
appliance must be installed in an area where the room temperature
corresponds to the relative climatic class.
Refer to the rating plate inside the appliance.
This appliance does not contain HFCs (replaced with R600a –
Isobutane). For more information, refer to the identification data plate
affixed to the appliance.
Description of the appliance with freezer compartment (Fig. 1)
1. Front panel
2. Light unit with thermostat knob
3. Shelves
4. Crisper drawers
5. Door trays
6. Defrost water drain
7. Freezer compartment door
Description of the appliance without freezer compartment (Fig. 2)
1. Front panel
2. Light unit with thermostat knob
3. Shelves
4. Crisper drawers
5. Door trays
6. Defrost water drain
Climatic
class
Ambient
temperature
SN between +10°C
and +32°C
Nbetween +16°C
and +32°C
ST between +18°C
and+38°C
Fig. 1
Fig. 2
6gb33014.fm Page 46 Wednesday, October 9, 2002 12:05 PM
47
SAFETY WARNINGS
• It is absolutely forbidden to use the following items
inside or near the appliance:
• electrical appliances with electrical motor (e.g.
blenders, hair driers to speed up defrosting);
• open flame;
• elements that can give off sparks;
• inflammable materials.
• Particular care must be taken to ensure that the
refrigerant pipelines at the rear of the appliance are
not damaged.
• Before any cleaning or maintenance operation,
unplug the appliance from the mains or disconnect
the electrical power supply.
• The appliance must be installed in a well-ventilated
place.
• Do not allow children to play with the packaging
materials - risk of suffocating.
• In the event that the refrigerant pipelines are
damaged and gas is released, the room where the
appliance is installed must be aerated for a few
minutes.
• Do not store gas or inflammable liquids inside the
appliance - risk of explosion.
SAFEGUARDING THE ENVIRONMENT
1.Packing
The packaging material is entirely recyclable, and
marked with the recycling symbol. Follow local
regulations for scrapping.
Keep the packaging materials (plastic bags, polystyrene
parts, etc.) out of reach of children, as they are
potentially dangerous.
2.Appliance
The appliance is made using recyclable materials.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. Make the
appliance unusable by cutting off the power cord.
The appliance must be delivered to an authorised
collection centre for the recovery of refrigerant gas.
Declaration of conformity
This appliance is intended to come into contact with
foodstuffs and conforms to D.L. 108 of 25.01.1992
(European Directive 89/109/EEC).
INSTALLATION
Door reversibility
To change the direction of door opening proceed as
follows:
• unscrew the bottom hinge;
• remove the door from the top hinge pin;
• unscrew the top hinge;
• screw the hinges on the other side of the appliance;
• fit the door on the top hinge pin and close it;
• screw the bottom hinge.
After changing the direction of door opening, check the
door seal and adjust it if necessary. To adjust the door
seal loosen the screws of the hinges and adjust them.
Electrical Connection
Electrical connections must be made in accordance
with local regulations. Ensure that the voltage indicated
on the appliance data plate corresponds to the
domestic supply voltage. Regulations require that the
appliance is earthed. The Manufacturer declines all
liabilities for injury to persons or damage to property
resulting from failure to observe these regulations. If
the plug and socket are not of the same type, have the
socket replaced by a qualified electrician. After
installation, make sure that the refrigerator is not
standing on the power supply cable.
Do not use extensions leads. The manufacturer
declines all liability for damages resulting from a
faulty electrical connection.
6gb33014.fm Page 47 Wednesday, October 9, 2002 12:05 PM
48
USING THE APPLIANCE
Switching on the refrigerator and adjusting the temperature.
Switching off the appliance
Do not switch on the refrigerator until it is in operating position. Wait
about 3 hours.
The appliance switches on when the thermostat knob is turned to a
position between 1 and 7 (Fig. 3).
For daily use we recommend to set the thermostat to an intermediate
position. There is no need to change the setting when the room
temperature changes.
In the event of prolonged disuse, it will be necessary to:
• turn the thermostat knob to “0”;
• unplug the appliance from the mains power supply;
• empty, clean and dry both compartments;
• leave the door open.
Energy saving
• Install the appliance away from heat sources;
• do not leave the door open for any longer than strictly necessary;
• the thickness of frost or ice on the walls of the freezer must not
exceed 5mm;
• do not place pots without lids or hot pots in the refrigerator.
When the room temperature is low, also electrical consumption is low.
Storing fresh food in the refrigerator
Fresh food compartment
The refrigerator compartment can be used to store fresh food.
• Food must be cooled at room temperature before placing it in the
refrigerator. Wrap and seal food in polythene bags, aluminium foil,
closed containers or pots to prevent it from absorbing and
transferring odours and humidity.
• The recommended maximum storage time for frozen foods is
indicated on the package. The longer one goes beyond the ‘best
before date’, the greater chance of food deterioration.
Fig. 3
6gb33014.fm Page 48 Wednesday, October 9, 2002 12:05 PM
49
Frozen food compartment
The temperature in this compartment is -18°C or lower.
Freezer compartment marked ****
This compartment can be used for storing frozen food or freezing up to
2 kg of fresh food in 24 hours. To freeze fresh food it is advisable to set
the thermostat to “5 - 6”. After 24 hours set the thermostat back to its
previous position.
Freezer compartment marked ***
This compartment can be used for storing frozen food.
Making ice cubes
The freezer compartment can be used for making ice cubes. To speed up
the ice making process, set the thermostat to “7”. After approximately
two hours ice is made.
Do not eat ice cubes or ice lollies immediately after taking them out of
the freezer compartment - risk of "cold" burns.
Defrosting the appliance
The frost that forms on the rear wall of the compartment is
automatically eliminated each time the compressor stops. The droplets
of water are routed to a drain outlet (2) and into a collection container
located on the compressor from which they evaporate.
During operation impurities can form and obstruct the drain outlet,
thus preventing the water from draining.
Any impurities must be removed from the water outlet using the
specific device (4) (Fig. 4).
The freezer compartment requires manual defrosting. To defrost,
proceed as follows:
• turn the thermostat knob to “0”;
• disconnect the appliance from the power supply by unplugging it;
• open the freezer compartment door to allow the frost to melt;
• remove the defrost water, and clean and dry the compartment;
• switch on the appliance again.
Do not use sharp objects or metal instruments to remove ice.
Fig. 4
6gb33014.fm Page 49 Wednesday, October 9, 2002 12:05 PM
50
MAINTENANCE
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. See if you can solve the problem yourself.
2. Switch the appliance on again to see if the problem
has been solved. If it has not, disconnect the
appliance from the power supply and wait for about
an hour before switching on again.
3. If the problem persists after this course of action,
contact After-sales Service.
Specify:
• the nature of the problem,
• the model,
• the Service number (the number after the word
SERVICE on the data plate on the inside of the
appliance),
• your full address,
• your telephone number and area code.
Note: The direction of door opening can be
changed. If this operation is performed by
After-sales Service it is not covered by the
warranty.
Replacing the bulb
To change the bulb, proceed as follows:
• turn the thermostat knob to “0”;
• unplug the appliance from the mains.
• remove the light cover (see Fig. 5);
• replace the bulb;
• refit the light cover;
• switch on the appliance again.
Use the following bulb:
- 220–240 [V]
- max. 15W
- thread E14
- max. dimensions of bulb:
• length 55mm
• diameter 26mm
Observe the indications and warnings contained in this manual
for correct and safe installation of the appliance, in order to avoid
damages resulting from improper use and to ensure long life of
our product.
Fig. 5
6gb33014.fm Page 50 Wednesday, October 9, 2002 12:05 PM
51
ELECTRICAL CONNECTION
1) For Great Britain only
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13amp fused
plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to
BS 1362 type and proceed as follows:
1.Remove the fuse cover (A) and fuse (B).
2.Fit replacement 13A fuse into fuse cover.
3.Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if the fuse cover
is lost the plug must not be used until a correct replacement is fitted.
Correct replacement are identified by the colour insert or the colour
embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical store.
2) For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but
a third type of plug and socket is also used, the
2-pin, side earth type.
3) Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact
Whirlpool Service for further instruction. Please do not attempt to
change plug yourself. This procedure needs to be carried out by a
qualified Whirlpool technician in compliance with the manufactures
instructions and current standard safety regulations.
6gb33014.fm Page 51 Wednesday, October 9, 2002 12:05 PM
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI