Panasonic MCCG691 Operating instructions
- Category
- Vacuum cleaners
- Type
- Operating instructions
This manual is also suitable for
Panasonic MCCG691 is a powerful and versatile vacuum cleaner that is perfect for cleaning all types of floors and surfaces. With its 1300W motor, it provides strong suction power to remove even the most stubborn dirt and debris. The variable power control allows you to adjust the suction power to suit the surface you are cleaning, and the telescopic wand and floor nozzle make it easy to reach even the most awkward areas. The MCCG691 also comes with a crevice nozzle, upholstery nozzle, and dusting brush, so you can clean everything from carpets and hard floors to furniture and curtains.
Panasonic MCCG691 is a powerful and versatile vacuum cleaner that is perfect for cleaning all types of floors and surfaces. With its 1300W motor, it provides strong suction power to remove even the most stubborn dirt and debris. The variable power control allows you to adjust the suction power to suit the surface you are cleaning, and the telescopic wand and floor nozzle make it easy to reach even the most awkward areas. The MCCG691 also comes with a crevice nozzle, upholstery nozzle, and dusting brush, so you can clean everything from carpets and hard floors to furniture and curtains.
Operating Instructions
Vacuum Cleaner
Model No.
MC-CG695K
MC-CG691K
2
SPECIFICATIONS MC-CG695K MC-CG691K
Power source
230-240 V ~ 50 Hz
Max. Input
1300 W
Nominal input
1100 W - 1200 W
Dimensions
(W x L x H)
300 mm x 440 mm x 235 mm
Net weight
5.0 kg
Extension wands
Telescopic
Crevice nozzle
√
Upholstery nozzle
√
Dusting brush
√
–
REMINDER FOR CUSTOMER
The model and serial number of this product may be found on the
nameplate located at the underside of your cleaner. You should note the
model and serial number in the spaces provided and retain this book as a
permanent record of your purchase.
Model Number. ........................ Serial No. ...............................................
Date Purchased. ...................... Where Purchased. ................................
ENGLISH
Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households)
This symbol on the products and/or accompanying documents means that used electrical and electronic products should not be
mixed with general household waste.
For proper treatment, recovery and recycling, please take these products to designated collection points, where they will be
accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your local retailer
upon the purchase of an equivalent new product.
Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on human health
and the environment which could otherwise arise from inappropriate waste handling. Please contact your local authority for further
details of your nearest designated collection point.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal.
3
TABLE OF CONTENTS
Page
Specifi cations ......................................................................... 2
Caution for AC Mains Lead
(UK and Republic of Ireland only) ......................................... 3
Important safety instructions for the user ........................... 3
Trouble Shooting .................................................................... 4
Page
Storing ..................................................................................... 5
Replacing the dust bag .......................................................... 5
Caring for your cleaner ......................................................... 5
Vacuum cleaner Consumables /Accessories
(For UK and Republic of Ireland customers only) ............... 6
CAUTION FOR AC MAINS LEAD (UK and Republic of Ireland only)
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY
This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A 13 amp fuse is fi tted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 13 amps and that it
is approved by ASTA or BSI to BS1362.
Check for the ASTA mark
or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover you must ensure that it is refi tted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUIT ABLE FOR THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE
SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO ANY
13 AMP SOCKET.
If a new plug is to be fi tted please observe the wiring code as shown below.
If in any doubt please consult a qualifi ed electrician.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Blue : Neutral
Brown : Live
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or
coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or
coloured RED.
Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter
E or the Earth Symbol
How to replace the Fuse:
• There are two types of the supplied AC Mains Lead A and B as shown below.
1 Open the fuse compartment with a screwdriver.
2 Replace the fuse and fuse cover if detachable.
TYPE A
TYPE B
IMPORTANT SAFETY INSTRUCTIONS FOR THE USER
Before using the vacuum cleaner, please observe these basic precautions.
WARNING: To reduce the risk of fi re, electric shock, or injury
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Do not use the appliance if the mains lead or plug is damaged or faulty.
• If the mains lead is damaged, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to
avoid a hazard.
• Unplug from the socket outlet when not in use and before cleaning the appliance or undertaking maintenance operations.
• Turn off the appliance before removing the plug. Do not pull on the mains lead, always pull on the plug body itself.
• Hold the plug, when rewinding the mains lead.
• Do not handle plug or vacuum cleaner with wet hands.
• Do not use wet fi lters after wash, make sure they are completely dry to avoid damaging the cleaner.
• Do not vacuum fl ammable or combustible substances, neither use in areas where they may be present.
• Do not vacuum hot ash, embers or large and sharp objects.
• Do not vacuum water or other liquids.
• Keep the vacuum cleaner away from heat sources such as radiators, fi res, direct sunlight, etc.
• This vacuum cleaner is fi tted with a thermal cut-out device which automatically turns off the cleaner to prevent overheating of the
motor. When this happens, disconnect the cleaner from the socket outlet and check the dust compartment and fi lters as they may
be full or clogged with fi ne dust. Check for any other obstructions in the hose or tube. After removing the obstruction, leave the
cleaner to cool down until the thermal cut-out resets after approximately 60 minutes.
4
Mains lead
Plug
Dust indicator
Turn the power control to the highest setting
and lift the nozzle off the fl oor. If the dust
indicator turns red, the dust bag is full and
requires replacing the dust bag.
Hose
Floor nozzle
MC-CG695K •
Release button
Dust cover
Dust bag (in body)
Please read the safety instructions (P.3) before using this cleaner. This product complies with the directives
2006/95/EC and 2004/108/EC.
CAUTIONS
The plug must be removed from the socket outlet before cleaning or maintaining the appliance.
●
DO NOT use hot air or hot surface to dry filters. Dry them at room temperature for approximately 24 hours.
●
IMPORTANT: Before re-installing the washable filters, make sure they are completely dry to avoid damaging
●
the appliance.
Alternative nozzles
Crevice nozzle:
For narrow gaps, etc.
Upholstery nozzle:
For cushions, covers,
etc.
Dusting brush
(MC-CG695K only)
Trouble Shooting
Please check the following first if you have any problems.
If your problem is still not solved, consult your local retailer.
‘It won’t switch on!’
Check that the plug is connected firmly and the socket outlet
is working normally.
(If a thermal cut-out device has activated, please wait approx.
60 minutes until it has reset)
If the product still does not work, please take it to an
authorized service centre for repair.
Variable power control
The dusting brush can be set
between the telescopic wand
and the floor nozzle if you want.
Remove the floor nozzle by
pressing the release pedal and
you can use the dusting brush
easily anytime.
(MC-CG695K only)
ON/OFF Switch
pedal
2
Adjust the nozzle
to suit the floor
Carpet
Parquet
flooring
MC-CG691K •
Carpet
Parquet
flooring
First, assemble the parts together.
(Hose, Telescopic wand, Floor nozzle)
MC-CG695K • MC-CG691K •
Align the raised
section with the
hole.
Parts are set surely so as not to come
off.
Cord rewind pedal
Press the mark,
not the edge of the
switch.
Telescopic wand
Length may be adjusted.
MC-CG695K • MC-CG691K •
1
Start operation
Press
Press the mark, not
the edge of the switch.
Adjust power
by turning
5
Storing
Please perform the following
before storing.
Storage position Park position
Turn off the power. ●
Rewind the mains lead. ●
(Hold the plug to ensure the mains lead
does not jump.)
Store the supplied nozzles.
●
Replacing the dust bag
Please replace a new
dust bag in the following
cases:
If the dust bag is not properly
installed, the dust cover will not close.
When the indicator turns red.
●
(Turn the power control to the higest
setting and lift the nozzle off the
floor.)
Suction power has dropped.
●
Caring for your cleaner
If suction power does not return after removing dust…
Check for blockages in hose, telescopic wand, and nozzles. Clean the pre-motor filter.
Cleaning
pre-motor
filter
Remove the dust bag first.
Remove the pre-motor filter and tap to
●
release dust.
Gently wash with water and dry in
●
shade if dust is not easily removed.
Cleaning
nozzle
Using an old toothbrush or similar
●
tool,clean any dirt or lint from the
brush.
Do not wash with water.
●
MC-CG695K • MC-CG691K •
After one year
has passed…
Replace the Exhaust filter.
●
Exhaust filter
(HEPA filter)
To close
●
Attention
Do not use detergent or any other cleaning liquids.
●
Do not wash the pre-motor filter in a washing machine or dry it with a dryer other source of hot air.
●
Attach the pre-motor filter correctly (to avoid damaging motor).
●
After long periods of use, you may notice a slight rubber smell. This is normal.
●
6
Vacuum Cleaner Consumables / Accessories
(For UK and Republic of Ireland customers only)
DESCRIPTION MC-CG695K MC-CG691K
Hose unit
AMV94P7B0V0E AMV94P7D0V0E
Telescopic wand
AMV99P7B000E
AMV99PUZ000E
Floor nozzle
AMV99R7B0V0E
AMV99R4D000E
Crevice nozzle AMC60RUA0K0E
Dusting brush AMV0UR5J0V0E
Upholstery nozzle AMV86R7B0K0E
Exhaust fi lter
(HEPA fi lter)
AMV95K7B0HEE
Dust bag
TYPE C-17H (PACK 4/u.)
AMC-J2EP
Filter
(Pre-motor fi lter)
AMV37K7B000E
Note: Specifi cations are subject to change without notice.
Sales and Support Information
Customer Care Centre
• For customers within the UK: 0844-844-3868
• For customers within the Republic of Ireland:
01 289 8333
• Visit our website for product information
• E-mail: customer[email protected]
Direct sales at Panasonic UK
• Order accessory and consumable items for your product with ease and
confi dence by phoning our Customer Care Centre Mon – Thu 9:00am – 5:30pm,
Fri 9:30am – 5:30pm. (Excluding public holidays).
• Or go on line through our Internet Accessory ordering application at
www.panasonic.co.uk
• Most major credit and debit cards accepted.
• All enquiries transactions and distribution facilities are provided directly by
Panasonic UK Ltd.
• It couldn’t be simpler!
• Also available through our internet is direct shopping for a wide range of fi nished
products, take a browse on our website for further details.
7
Pursuant to the directive 2004/108/EC, article 9 (2)
Panasonic Testing Centre
Panasonic Service Europe, a division of
Panasonic Marketing Europe GmbH
Winsbergring 15, 22525 Hamburg, F.R. Germany
http://www.panasonic.net/
© Panasonic Corporation 2009
V01Z7B208
S0209-5069
Printed in China
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Panasonic MCCG691 Operating instructions
- Category
- Vacuum cleaners
- Type
- Operating instructions
- This manual is also suitable for
Panasonic MCCG691 is a powerful and versatile vacuum cleaner that is perfect for cleaning all types of floors and surfaces. With its 1300W motor, it provides strong suction power to remove even the most stubborn dirt and debris. The variable power control allows you to adjust the suction power to suit the surface you are cleaning, and the telescopic wand and floor nozzle make it easy to reach even the most awkward areas. The MCCG691 also comes with a crevice nozzle, upholstery nozzle, and dusting brush, so you can clean everything from carpets and hard floors to furniture and curtains.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Panasonic FY350ZDY8R Operating instructions
-
-
-
-
-
-
-
-
-