27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 654985
654985 ProClip
Center mount. ONLY for models with keyless ignition. Will interfere with key on other models.
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient - always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320286549851
Item no 654985 fits:
Kia Sorento 13-14 (For all countries)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the ProClip. This ProClip consists of
two parts:
Part 1: Attaching part (the smallest part)
Part 2: ProClip face plate
1. Press the thin end of the enclosed gap opener into the gap under the Start button, to widen the gap. Use the
enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel off the adhesive tape cover on
Part 1. Press the angled edge on Part 1 into the gap next to the gap opener.
2. Press Part 1 upward/forward, so the angled edge goes all the way into the gap and hooks behind the control
panel and the adhesive tape attaches. Pull out the gap opener.
3. Open up the predrilled holes in Part 2 with a screwdriver. Peel off the adhesive tape cover on Part 2. Place
Part 2 onto Part 1 so the holes match and the face plate is on the right side. Attach Part 2 onto Part 1 by using
the enclosed screws. Whil screwing, keep the ProClip in place using your index finger and press it
forward/upward with your thumb to ensure the screw goes all the way in and the ProClip attaches correctly.
4. The ProClip is in place.
2(2)
/