IDX TA-CA238 Operating instructions

Brand
IDX
Model
TA-CA238
Type
Operating instructions

This manual is also suitable for

TA-CA214 / TA-CA238
Camera Support Accessory
Instruction Manual
Thank you for purchasing the TA-CA2(14/38) camera support accessory. TA-CA2(14/38) is de-
signed to be used with handheld and DSLR type cameras. It enables the ability to mount 14.4V
ENDURA V-Mount batteries and accessories to simultaneously supply DC power to the camera
and camera accessories. In addition, the TA-CA2(14/38) can be adapted to larger camera sys-
tems for flexible accessory mounting. Prior to using TA-CA2(14/38), IDX recommends reading
this Instruction Manual on how to best use TA-CA2(14/38).
Features
Parts List
1. Cheese plate “A” mounts to the bottom of a handheld type camera with a 1/4-20” or 3/8-16”.
screw.
2. Attach cheese plate “B” to the ball-joint clamp in any of the cheese plate’s 1/4-20” screw holes.
General Notes & Safety
TA-CA2(14/38) will not mount underneath all handheld cameras. The camera’s 1/4-20” or 3/8-16”
screw hole must be less than 4.5” or 3.7”, respectively, from the rear of the camera.
Do not attempt to modify this unit. All work should be carried out by IDX authorized
service personnel only.
Tighten all levers and screws prior to use to avoid injury and equipment damage.
If you need any inspection or repairs, please contact your local IDX dealer or IDX office.
IDX System Technology, Inc.
19001 Harborgate Way, Suite 105 Torrance, CA 90501
Tel: +1-310-328-2850
Fax: +1-310-328-8202
Email: [email protected]
www.idxtek.com
07232013
Cheese plate “A” with ball-joint clamp Cheese plate “B” 1/4-20” Screw 3/8-16” Screw
Specifications
 Various handheld and still cameras can be
mounted.
 Compatible with all P-V series plates.
 Regulated DC voltage from optional P-V se-
ries plate with ENDURA battery enables
longer operation time.
 Ball-joint clamp and cheese plate design
enables fully customizable configurations.
 Many mono/tripod adaptors can be mounted.
 Dimensions:
15.66 (L) x 3.24 (W) x 0.39 (H) inches *
*Fully extended.
 Weight: 1.25 lbs.
 Material: 6061 aluminum, black anodized.
 Included accessories: 1/4-20” (TA-CA214) or
3/8-16” (TA-CA238) camera mounting
screws.
Assembly and Mounting Instructions (continued)
3. Attach an optional P-V series plate with the appropriate voltage regulation/DC cable.
4. Adjust the plate’s position to your liking and tighten the ball-joint clamp by turning the lever.
5. Attach an optional DC-DC cable to the P-V series plate and camera.
*please call or visit our website to check which P-V series plate and DC-DC cable is compatible
with your camera.
Assembly and Mounting Instructions
Usage Examples
Compact Chest Support Under Support
  • Page 1 1

IDX TA-CA238 Operating instructions

Brand
IDX
Model
TA-CA238
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents