Sunricher SRP-2309-10CCT350-700 User manual

Type
User manual

Sunricher SRP-2309-10CCT350-700 is a 10W dimmable LED driver with two channels and a constant current output. It is compatible with universal DALI masters that support DT8 commands and has a built-in DALI-2/Push interface. The driver can be used to switch and dim Tunable White LED lighting fixtures and offers smooth and deep dimming to 0.1%. It supports hybrid (PWM+CCR) dimming and has an error report function. The driver is IP20 rated, suitable for indoor LED lighting applications, and comes with a 5-year warranty.

Sunricher SRP-2309-10CCT350-700 is a 10W dimmable LED driver with two channels and a constant current output. It is compatible with universal DALI masters that support DT8 commands and has a built-in DALI-2/Push interface. The driver can be used to switch and dim Tunable White LED lighting fixtures and offers smooth and deep dimming to 0.1%. It supports hybrid (PWM+CCR) dimming and has an error report function. The driver is IP20 rated, suitable for indoor LED lighting applications, and comes with a 5-year warranty.

MTBF
Dimension
Warranty 5 Years
103.7*52.6*30mm (L*W*H)
Others
• Built-in DALI-2/Push interface, DALI DT8 device
• IP20 rating, suitable for indoor LED lighting applications
Error report function
Compatible with universal DALI masters that support DT8 commands
• Class Ⅱ power supply, full isolated plastic case
5 years warranty
• High power factor and efficiency
Dimmable LED driver. Max. output power 10W
Hybrid(PWM+CCR) dimming, smooth and deep dimming to 0.1%
• To switch and dim Tunable White LED lighting fixtures
In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2.IEC 62386-209:2011
• 2 channel 350~700mA constant current output, select by DIP switch
Safety Standards EN61347-1, EN61347-2-13
EMC Emission EN55015, EN61000-3-2, EN61000-3-3
EMC Immunity
Isolation Resistance
EN61547, EN61000-4-2,3,4,5,6,8,11, surge immunity Line-Line 0.5KV
Withstand Voltage I/P-O/P: 3.75KVAC
I/P-O/P: 100M ohms / 500VDC/ 25°C /70%RH
Safety&EMC
Operation
• DO NOT set the operation current with power applied
• DO NOT expose the device to moisture.
• DO NOT install with power applied to device.
Safety & Warnings
1 DALI addresses for 2 channel output is assigned by DALI Master controller automatically, please refer to user
manuals of compatible DALI Masters for specific operations.
1. DALI Address Assigned by DALI Masters
Working Temp. -20℃ ~ +45℃
Working Humidity 10% ~ 95% RH non-condensing
Storage Temp. &
Humidity -40℃ ~ +80, 10% ~ 95% RH
Max. Case Temp. 85℃ (Ta="45℃")
Environment
Dips to set the operation current
1 2 350mA
450mA
600mA
700mA
12
191200H, MIL-HDBK-217F @ 230VAC at full load and 25℃
ambient temperature
Product Data
Voltage Range 200-240V AC
Power Factor (Typ.) >0.9@230VAC
Input Current
Standby Power consumption
Anti Surge
0.053A @ 230VAC
<0.5W
L-N:500V
Total Harmonic Distortion THD≤15 (@Full load/230VAC)
Frequency 50/60Hz
Input
Over Current Yes, auto recovery after fault removed
Over Temperature Yes, recovers automatically after temperature drop
Short Circuit Yes, auto recovery after fault removed
Protection
Control
Dimming Interface
Dimming Range
Dimming Method
Dimming Curve
0.1%-100%
DALI Device Type 8 (DALI consumption<2mA)
Hybrid (PWM +CCR) dimming
Logarithmic
Inrush C urrent (Typ.)
COLD START Max. 8A @ 230VAC
Current Accuracy ±3%
Output
Selectable Current 350mA 450mA 600mA 700mA
DC Voltage Range
2 Channel
LED Channel
Rated Power Max.10W
6-28V 6-22V 6-17V 6-14V
DALI Dimmable Driver
CW
WW
DA
DA
DALI
L
N
AC INPUT LED OUTPUT
AC Power input
DALI signal input
2 channel LED output
Dips to set the operation current
10W DALI DT8 LED Driver(Constant current
Function introduction
Important: Read All Instructions Prior to Installation
2
Wiring Diagram
DALI bus DA
DA
1. With DALI bus
L
N
Product Dimension
103.7 mm
30 mm
52.6 mm
DALI Dimmable Driver
WW
CW
DA
DA
DALI
N
L
AC INPUT LED OUTPUT
LED light
  • Page 1 1
  • Page 2 2

Sunricher SRP-2309-10CCT350-700 User manual

Type
User manual

Sunricher SRP-2309-10CCT350-700 is a 10W dimmable LED driver with two channels and a constant current output. It is compatible with universal DALI masters that support DT8 commands and has a built-in DALI-2/Push interface. The driver can be used to switch and dim Tunable White LED lighting fixtures and offers smooth and deep dimming to 0.1%. It supports hybrid (PWM+CCR) dimming and has an error report function. The driver is IP20 rated, suitable for indoor LED lighting applications, and comes with a 5-year warranty.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI