2. ROOMS TO GO
  3. 30936023

ROOMS TO GO 30936023, 30836021, 30836033, 30936035 Assembly Instructions

  • Hello! I've reviewed the user manual for the 33640 Headboard. This manual includes detailed instructions for assembly, such as connecting split headboard components and adjusting the headboard height. I'm ready to answer any specific questions you may have about assembling or using the headboard.
  • What should I use when placing the furniture on non-carpeted flooring?
    Where are the bed parts shipped?
    How can I adjust the height of the headboard?
REV 01
33640 Headboard
CAUTION:
PLEASE CONTACT US FOR QUESTIONS
Email our support team: [email protected]o
When placing furniture on non-carpeted flooring,
we recommend the use of floor protecon such as
an area rug or furniture pads. Area rugs and
padding not included with purchase.
Estimated Time for Assembly
10:00 - 15:00
Bed parts are shipped inside a compartment in the back
of the right half side of headboard view from back.
PLEASE CONTACT US FOR QUESTIONS
Email our support team: [email protected]o
Remove parts from headboard
compartment
PLEASE CONTACT US FOR QUESTIONS
Email our support team: [email protected]o
Hardware
Components
Split Headboard
PACKAGE CONTENT
( L )
( R )
1 set
1 set
6 pcs
M6X50
L
5 pcs
M8
O
3 pcs
M8
P
4 pcs
M8X50
S
8 pcs
M8
O
8 pcs
M8
U
1 pc
M5
R
4 pcs
M8
V
1 pcs
X
5 pcs
M8X50
M
6 pcs
M6
O2
Hardware bag for
assembly metal bed base
1 set
C
Assembly at
back of headboard
M
O
P
R
A
A
1.
3 pcs
M8X50
+PO
+
M
Aach“P”and“O”washersto“M”bolt.
Connect two parts of “A” together.
Use the bolts to a ach.
2 pcs
M8X50
+O
M
2.
A
A
C
R
M
O
C
A ach“O” washer to “M” bolt.
Connect the wood rail “C” to back
of headboard “A”.
Use the bolts to a ach.
6 pcs
M6X50
+O2
L
3.
A
A
B
B
( L )
( R )
R
L
O2
A ach“O2” washer to “L” bolt.
Connect the leg “B” to back of
headboard “A”.
Use the bolts to a ach.
Headboard height can be adjusted to 3 posions.
Use upper holes for a thin ma ress or lower holes for a thick ma ress.
Select the proper posion for your desired bed height.
B
A
4.
(Bed frame is not included.)
A ach “U” and “O” washers to bolt “S”. Hold the bolts “S” steady with the “R”
Allen wrench. A ach a “V” nut and “O” washer to the other side of the bolt as
shown. Tighten the nut against the bed frame bracket with the “X” wrench.
( L )
( R )
NEED ADDITIONAL HELP?
Email our support team: [email protected]
/