Instruction Manual for
Telescope with Tripod
Assembling Your Telescope
1. Spread the tripod legs and push down on the center tripod support struts until the tripod legs
are spread as wide as they can and the tripod support struts are straight.
2. Carefully push the telescope down into the telescope attachment bracket on the tripod until it is firmly
held in place.
Using Your Telescope
1. Remove the plastic dust cap from in front of the 30mm objective lens.
2. Loosen the horizontal motion lock and the vertical motion lock by turning the knobs
counterclockwise.
3. Aim the telescope at the subject you want to look at.
4. Place your eye just behind the eyepiece.
5. Slowly push, pull, or turn the eyepiece until you see your subject sharply.
6. If you want to keep your telescope aimed in this direction, tighten the horizontal and vertical motion
locks by turning them clockwise.
Hand-holding Your Telescope
While firmly holding the tripod with one hand, gently pull the telescope up and out of the telescope
attachment bracket. You can now hold it up to your eye like an old-fashioned 'spy glass.' You will have
to hold your telescope steady, or everything will look like it is shaking.
WARNING:
DO NOT LOOK AT OR NEAR THE SUN.
PERMANENT EYE DAMAGE MAY RESULT.
TELESCOPES SHOULD BE USED UNDER ADULT SUPERVISION.
At Protocol, we’re dedicated to bringing you well-designed products that make living fun and easy.
We stand behind all our products and warrant this to be free from defects in workmanship and
materials for 1 year from the date of purchase.
For service claims and questions please consult our website ProtocolNY.com or you may call
toll-free at 1-800-261-1193.
Horizontal motion lock
Telescope body
30mm objective lens
Eyepiece
Legs
Support struts
Telescope attachment bracket
Vertical motion lock
Telescope:
Tripod:
/