Magnescale LH72 Owner's manual

  • Hello! I have reviewed the user manual for the Magnescale LH72 Preset Operation. This manual describes how to set and recall up to three preset values per axis. The device features simple and full numerical input methods, and uses a flashing segment to indicate the active input field. I'm ready to assist you with any questions you have about this device and its operation.
  • How many preset values can I save?
    How do I start the preset operation?
    How do I confirm a preset value after entering it?
1/1
Preset operation (LH72)
Enter the set value with the numerical keys and confirm the value with key.
Example: -15.0000
This describes a preset operation that sets an arbitrary value.
Up to 3 preset values can be saved.
Preset operation (LH72)
Ver.3 (2021.1) CS&S
Makes the preset operation possible.
Press key. ( lamp lighting)
Press key for the axis you want to set.
The leftmost segment flashes.
If you have previously entered a preset value, that value will be displayed.
Up to 3 preset values can be set for each axis
You can enter the following preset values by pressing key on the axis you want to set and then pressing key.
The leftmost segment flashes
Setting preset values
(Example: X-axis)
NOTE: INC display is fixed during preset mode
Recall preset values
If you have set preset values in the past, pressing key will display the preset values in sequence.
Preset value 1
Preset value 2
Preset value 3
Up to 3 preset values can be set for each axis
Press key to end the preset operation. ( lamp off.
Press key to confirm the preset value you entered.
Method 2 (input all numerical values)
Method 1 (simple input)
If you have set preset values in the past, pressing key will display the preset values in sequence.
Makes the preset operation possible.
Press key. ( lamp lighting)
Press key for the axis you want to set.
The leftmost segment flashes.
If you have previously entered a preset value, that value will be displayed.
Press key to end the preset operation. ( lamp off.
Press key to confirm the preset value you entered.
/