CyberData 011201 Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the CyberData 011201 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The IP Endpoint Company
Quick Reference 930483E © 2019, CyberData Corporation, ALL RIGHTS RESERVED.
Installation Quick Reference
Ceiling Tile Auxiliary Analog Drop-In Speaker
011201
Parts
(1) 1 x 2 Ceiling Tile Speaker Assembly
FIts 12-inches x 24-inches and 24-inches x 48-inches ceiling tile
(1) Cross Tee
Dimensions
23.625 [600]
11.750 [298.5]
Approx. 3.510 [89.2]
Dimensions are in
Inches [Millimeter]
Contacting CyberData
Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: (831) 373-2601 ext. 136
RMA Email: [email protected]
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
http://www.cyberdata.net/
© 2019, CyberData Corporation, ALL RIGHTS RESERVED. 930483E Quick Reference
Installation Procedure
To install the Ceiling Tile Auxiliary Analog Drop-In Speaker, complete the following steps while referencing the figure
below:
1. Remove the Ceiling Tile (Showing a 2 x 2 Grid) from the Ceiling Grid then Cut it in Half.
2. Place the Cross T in the Middle to Support the Weak Side of the Ceiling Tile.
3. Replace the Ceiling Tile on to the Ceiling Grid.
4. Use a Flat Blade Screwdriver to Pry Up the Seismic Tether Bracket(s) on the 1 x 2 Ceiling Tile Speaker
Assembly.
5. Install Eyebolt(s) or Nail(s) to the Joist.
6. Connect the Network Cable to the Network Port and Wire(s) to the Terminal Block, etc. to the 1 x 2 Ceiling Tile
Speaker Assembly.
7. Use Steel Wire(s) to Connect Seismic Tether Bracket(s) to the Eyebolt(s) or Nail(s). Place the 1 x 2 Ceiling Tile
Speaker Assembly on to the Ceiling Grid and the Cross T.
Installing the Ceiling Tile Auxiliary Analog Drop-In Speaker
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
Cross T
*
*
**
*
Speaker Assembly
2 x 2 Ceiling Tile
Steel Wire
1 x 2 Ceiling Tile
OLD
Use a Flat Blade Screwdriver
to Pry Up the Seismic Tether Bracket
Joist
Eyebolt / Nail
Cross T
*
*
*
*
*
Speaker Assembly
2 x 2 Ceiling Tile
Steel Wire
1 x 2 Ceiling Tile
2
8
4
5
1, 3
6
7
/