• If the mains socket is loose, do not
connect the mains plug.
• Do not pull the mains cable to
disconnect the appliance. Always pull
the mains plug.
• Use only correct isolation devices: line
protecting cut-outs, fuses (screw type
fuses removed from the holder), earth
leakage trips and contactors.
• The electrical installation must have
an isolation device which lets you
disconnect the appliance from the
mains at all poles. The isolation
device must have a contact opening
width of minimum 3 mm.
• Fully close the appliance door, before
you connect the mains plug to the
mains socket.
2.3 Gas connection
• All gas connections should be made
by a qualified person.
• Before installation, make sure that the
local distribution conditions (nature of
the gas and gas pressure) and the
adjustment of the appliance are
compatible.
• Make sure that there is air circulation
around the appliance.
• The information about the gas supply
is on the rating plate.
• This appliance is not connected to a
device, which evacuates the products
of combustion. Make sure to connect
the appliance according to current
installation regulations. Pay attention
to requirements regarding adequate
ventilation.
• This appliance requires an operating
pressure of 2.8 - 3.0 kPa at the
appliance. A suitable LPG regulator
that complies with the requirements
of SANS 1237 must be installed.
• Important information for the user.
This appliance may only be installed
by a registered SAQCC Gas installer.
All registered installers are issued with
a card carrying their registration
number. Ask to be shown the card
before allowing the installation work
to commence and make a note of the
Installer registration number. Upon
completion of the installation, the
installer is required to explain the
operational details of the appliance
together with the safety instructions.
You will be asked to sign the
acceptance of the installation and be
provided with the completion
certificate. You should only sign the
acceptance of the installation when
the installation is completed to your
satisfaction. Note that your invoice is
required if you wish to make a
guarantee claim.
• Important information for the
installer.This appliance may only be
installed by a gas installer registered
with the South African qualification
and certification committee (SAQCC).
The appliance must be installed in
accordance with the requirements of
SANS 10087-1 for use with LPG, SANS
827 for use with NG and any fire
department regulations and/or local
bylaws applicable to the area. If in
doubt, check with the relevant
authority before undertaking the
installation. Upon completion of the
installation you are required to fully
explain and demonstrate to the user
the operational details and safety
practices applicable to the appliance
and the installation.
2.4 Use
WARNING!
Risk of injury and burns.
Risk of electrical shock.
• This appliance is for household use
only.
• Do not change the specification of
this appliance.
• Make sure that the ventilation
openings are not blocked.
• Do not let the appliance stay
unattended during operation.
• Deactivate the appliance after each
use.
• Be careful when you open the
appliance door while the appliance is
in operation. Hot air can release.
• Do not operate the appliance with
wet hands or when it has contact with
water.
• Do not use the appliance as a work
surface or as a storage surface.
www.aeg.com
6