FMI GWMS2 Operating instructions

FMI
Brand
FMI
Model
GWMS2
Category
Car kits
Type
Operating instructions
GWMS2 Wall Mounted Switch Kit
For Use With FMI PRODUCTS, LLC Manufactured
Remote-Ready Log Sets, Cast Iron Stoves or Fireplace Systems
Installation Instructions
104919-01
Rev. D
02/12
Contents Of Kit
• Switch P/N 104514-01
• Switch Cover P/N 104514-02
• 25 ft. Wire P/N 14128
• Mounting Screws (2)
Installation and connection:
Note: Remove factory installed jumper wire (if installed).
Jumper wire is connected to TP/TH and TH terminals if ap-
plicable.
WARNING: Do not connect this switch or log set
to an electrical source! Electrical shock and/or re
hazard will occur.
Figure 1 - Connecting Wire Terminals
GAS VALVE
WALL SWITCH
2701 S. Harbor Blvd.
Santa Ana, CA 92704
1-866-328-4537
www.fmiproducts.com
1. Connect one wire terminal to the “TH” terminal and the
other wire terminal to the ''THTP''on the control valve
(see Figure 1).
2. Route the 25 ft. wire to a convenient location.
IMPORTANT: The wire may be shortened but must not
be lengthened.
3. Connect both bare wire ends to each of the terminals of
the provided wall switch.
4. Install the wall switch and cover in the wall.
  • Page 1 1

FMI GWMS2 Operating instructions

FMI
Brand
FMI
Model
GWMS2
Category
Car kits
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents