2
Getting Started
4.
S200/S330/G2 Black Users Only:
Set the camera’s Mode dial to .
5.
Turn on the digital camera.
6.
The symbol appears on the camera LCD monitor, and the power/mode
indicator is lit (green) when the printer is properly connected to the camera.
Disconnecting the Camera from the Printer
1.
To remove the camera cable, disconnect the cable on the printer side and turn
off the digital camera.
2.
When the printer is disconnected, the symbol disappears from the LCD
monitor, and the camera reverts to standard replay mode.
When connecting the PowerShot S30/S40/
S330 camera to a Bubble Jet printer:
•
Use the DIF-B100 direct interface cable
provided with the printer. When you insert
the cable, make sure the symbol on the
cable connector faces the rear of the camera.
When connecting the PowerShot S200/
G2 Black camera:
•
Use the DIF-B250 direct interface cable
provided with the printer. When you insert
the cable, make sure the symbol on the
cable connector faces the rear of the camera.
See the
Quick Start Guide
for your Bubble Jet printer for instructions
on installing paper and ink cartridges in the printer.
Direct Interface
Cable DIF-B100
Direct Interface
Cable DIF-B250
When you detach the cable from the camera, hold the plug, and
do not pull by the cable.
bubbleJetDirect.book Page 2 Tuesday, April 30, 2002 12:33 PM