Argos Cube Rattan Effect 4 Seater Patio Set User manual

Type
User manual

This manual is also suitable for

309/3715
3
3
Issue 2: 05/ 1 1/12
nuts
Please open all 3 boxes before commencing assembly of the set.
This box contains 1 table leg, 2 chairs and 2 pillows.
339/3642
3
S afety and Care Advice
Important Pl e a se read the se instructions fully be fore starting asse mbly
• Check you have all the
components and tools listed on
pages 2.
plastic bags and separate them
into their groups.
• Keep child ren and animals
away from the work area, small
parts could choke if swallowed.
• Make su re you have enough
space to layout the parts before
starting.
• Do not stand or put weight on the
product during assembly, this could
cause damage.
• Assemble the item as close
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
chair or your floor.
• Parts of the assembly will be
easier with 2 people.
We do not
recommend the
use of power
drill/drivers for
inserting screws ,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
ca efully and responsibly.
Care and mainte nance
• Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
r
the e are no loose nuts on
• F om time to time check that
r
this chair.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
• Make sure each studs
matches the corresponding
figure to ensure correct
assembly.
• Assemble all parts and nuts
loosely during assembly,only
once the product is complete
should you fully tighten the
nuts.
• Maximum safe seated
weight: 110kgs.
The quantities below are the correct amount to complete the assembly.In some cases more
fittings may be supplied than are required.
1
2
3
4
5
6
C
Tools required
Stud x 9
Washer x 9
Nut x 9

6X1.0
M6
M6x45
3
A s s e m b l y I n s t r u c t i o n s
Use stud ,washer ,
and
nut to fix the seat
panel to back panel
by wrench.
C
2
4
C
2
4
Use stud ,washer ,
and
nut to fix the left
panel and right panel
to back panel by
wrench.
C
1
3
2
C
3
1
2
Right
Do not fully tighten
nuts at this stage.
Do not fully tighten
nuts at this stage.
3
nuts
Assembly Instructions
and cushion
chair
5
6
5
6
After all the parts are positioned, you can now fully
tighten all nuts fixed on previous steps.
nuts
304/2223
Issue 2: 05/11/12
Please open all 3 boxes before commencing assembly of the set.
This box contains 1 table top and 4 chair cushions.
0345
31
Suggest to complete
this product assembly by
two person.
table,
lift the table, do not drag.
c
8xWasher
D
1 2 3
4 5
2
Ruler - Use this ruler to help correctly identify the screws
                  
            

to
A
C
C
D
and
1
2
3
3
3
2
1
1
2
D
B
Warning:Don’t detach the plastic support
from the table frame and keep away from
baby and children! It is for glass support!
tighten all the screws.
. Then
4
4
1
2
5
2
1
5
4
0345
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

Argos Cube Rattan Effect 4 Seater Patio Set User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI