Acctim 60002 Operating instructions

Brand: Acctim

Model: 60002

Category: Watches

Type: Operating instructions

Acctim 60002

The Acctim 60002 is a solar-powered radio-controlled chronometer watch that combines precise timekeeping with advanced features for convenience and functionality.

Atomic Radio Control: Synchronizes with atomic clocks in Germany or the UK for unmatched accuracy, automatically adjusting for daylight saving time and standard time.
Solar Power: Charges through sunlight or indoor light, eliminating the need for frequent battery replacements.
Battery Indicator: Alerts you when the battery is low, ensuring uninterrupted operation.
Stopwatch Function: Measures time up to 60 minutes in seconds, perfect for sports, cooking, and other timing tasks.

Acctim 60002

The Acctim 60002 is a solar-powered radio-controlled chronometer watch that combines precise timekeeping with advanced features for convenience and functionality.

Atomic Radio Control: Synchronizes with atomic clocks in Germany or the UK for unmatched accuracy, automatically adjusting for daylight saving time and standard time.
Solar Power: Charges through sunlight or indoor light, eliminating the need for frequent battery replacements.
Battery Indicator: Alerts you when the battery is low, ensuring uninterrupted operation.
Stopwatch Function: Measures time up to 60 minutes in seconds, perfect for sports, cooking, and other timing tasks.

3.About your watch

2. Initial Activation

4. Battery replacement

Mode button

Press Once for

signal indictor

Button(D)

Calibration for RCC

SYNC

Button ( C )

Mode button

Fig.4 Watch attempting to synchronize when it is at RX

Successful receive signal No signal

Fig.1 Atomic radio controlled time signal transmission and reception

Press twice

for day or week

Fig.2

Mainflingen

SOLAR POWERED RADIO CONTROLLED CHRONOMETER WATCH

Thank you for your purchase of this quality watch. The utmost care

has gone into the design and manufacture of your watch. Please read

these instructions carefully and store them in a safe place for future

reference.

1. What is Atomic Radio Control ?

The most precise time keeping device on earth is the atomic clock. It

keeps time to the accuracy of better than 1 second for every million

years. The atomic clock is a huge piece of scientific equipment and it

is so expensive that it is normally found in laboratories and standards

institutions etc. Thanks to the latest technology, the accuracy of the

atomic clock is now brought to your home. The radio station is

broadcasting electronically encoded time signals based on an atomic

clock from an antenna in Mainflingen of Germany ( DCF version) or

Anthorn of UK ( MSF version) to cover the mainland of their country.

The signal is picked up by the radio receiver circuit in your watch, and

is then decoded to synchronize the time to within a split of a second

precision. The radio signal automatically sets the calendar and

daylight saving or standard time too.

Your new watch may be shipped from the factory in the “OFF” mode

(all hands at 12:00 position) with crown pull out to save battery life.

To activate it, simply push the crown back to normal position and

press and hold the button D (SYNC button) for 5 seconds for

Synchronization.

Note: Please be sure that all hands are at the 12:00 position

before you push the crown back to normal position.

NOTE:

1. Dispose of the used batteries properly, in accordance to the

environmental laws in your area.

5.Battery management

Your solar atomic radio controlled watch can be powered by solar

power panel and normal battery. When battery level is low, the

bottom second hand will point at L.B. with the second hand move

every 2 seconds. If battery is not replaced in time, all hands will stop

at 12 o'clock position. Then you need to replace the new CR2016

battery.

6.Re-calibrating the watch hands for Radio controlled

Note:

* Only calibrate the watch hands after changing the battery or when

the watch is not setting correctly.

* Before calibrating for RCC function, check if the Stopwatch second

and minute hands are at “0” (12 0'clock) position. If not, please follow

Calibrating the Stopwatch hand Position.

a)Watch Hand Calibration for RCC function

To reset the hands to zero (12:00) position, please following steps:

1.Pull out the crown when the second hand is at 12:00 position.

2.Turn the crown to set the hour and minute hands to 12:00 position.

3.Push back the crown to normal position.

4.Press and hold the hidden pusher button D for 5 seconds, then the

hour, minute and second hands will stop.

5.The bottom second hand will turn to RX and start synchronization.

7. Auto-synchronization

Once batteries are installed and calibrated the watch hands for radio

controlled function, the receiver circuit is activated. The bottom

second hands will point at RX and all hands will stop running (See

Fig.4). If the watch is too close to electrical appliances such as TV,

mobile phone and computer, they may cause undesirable signal

interference. Strong signal is normally found close to the window. In

some areas where the signal is poor or less, you may need to position

and rotate the watch close to the window.

It normally takes 3 to 10 minutes to synchronize. Once it is successful,

the watch will show extremely accurate time and the correct day of

week (by pressing the MODE button two times). Successful

synchronization is symbolized pressing the mode button once and the

bottom second hands point at OK while it is pointed at NG if it does not

receive signal. A properly synchronized watch attempts to adjust

itself with the radio time signal every morning and if it fails for more

than 3 days, the small second hands will point to NG. 30 days failure

to synchronize will shut off the synchronization and function as a

quartz watch until you activate forced synchronization.

OPERATING INSTRUCTIONS

b)Quick calibration for second hand.

Your watch is a very delicate and precise instrument. Although

uncommon, sometimes hard knocks or vibrations can cause the

hands to move irregularly, and therefore display the incorrect time,

although the internal clock is keeping accurate time. You may notice

this if when you press button (D)for 5 seconds. If the second hand

does not point at 12:00 position, this means the second hand is off.

Please follow below steps:

1.Press button (D)for 5 seconds and the second hand will turn to

12:00 position.

2.If it is off, you can press button (A) to forward the second hand or

button (B) to backward the second hand to 12:00 position within the

first 20 seconds after pressing button (D) for 5 seconds.

After calibrated the second hand, the watch will start SYNC for the

accurate time.

1. The watch uses 1 CR2016 battery.

2. Battery replacement: Open the back cover of the watch. (See Fig.

3a)Take away the metal plate of + polarities. (See Fig. 3b) Replace

with CR2016 button cell with positive pole (+) facing outwards and

make sure that it is retained securely in position by the metal plate.

After finished, replace the back cover.

Fig.3a Fig.3b

EX.)Basketball game(Press the buttons in the following order:

( A) →(A)/(A) →…→(A) →(B)

1.Pull out the crown when the

second hand is at the 12 0'

clock position. The second

hand will stop on the spot.

*Do not press any button..

Otherwise, the chronograph

Hands will move.

1. pull out the crown. 2.Press button (A)or (B) to reset the

stopwatch second and minute hands

to “0”position.

*By pressing button (A),the hands

move clockwise.

*By pressing button (B),the hands

move counter clockwise.

3.Push the crown back the

Normal position.

3.Push the crown back in to the

normal position in accordance

with a time signal.

2.Turn the crown to set the hour,

minute and 24-hour hands to the

desired time.

As the hour hand moves, the 24-

hour hand also moves correspondingly.

when setting the hour hand, check

that the 24-hour hand is set properly.

RESET

(Reset to “0'0 0”)

START

(Start of game) →

RESET

STOPSTOP (Time out)

RESTART

(Restart of game) (Game over) →

→

START → STOP (Finish) →

a) Calibrating the Stopwatch hand Position

Before setting the time, check if the Stopwatch second and minute

hands are at “0” (12 0'clock) position.

If the stopwatch is in use, press the button in the following order to

reset it, and then, check if the hands return to “0” position. (For

details, see “HOW TO USE THE STOPWATCH”)

If the stopwatch is counting: (A) → (B)

If the stopwatch is stopped: (B)

If either of the stopwatch hands are not at the “0” position, reset them

following the procedure below:

Note: When you push out the crown and push back the crown, the

RCC function will be eliminated. To activate the RCC function, please

follow the Watch Hand Calibration for RCC function

b) Time Setting for non-RCC function

*Before setting the time, check that the chronograph measurement is

stopped.

10. How to use the Stopwatch

*The measured time is indicated by the stopwatch hands that move

independently of the center and 24-hour hands.

*The stopwatch can measure up to 60 minutes in seconds.

(Standard measurement)

EX.) 100m race (Press the buttons in the following order

(A) → (A) → (B)

(Accumulated elapsed time measurement)

*Restart and stop of the stopwatch can be repeated as many times as

necessary by pressing button(A).

PI-EXW2169

Environmental Protection

Disposal of electrical & electronic equipment

Do not dispose of this product with household waste. For

the proper treatment, recovery and recycling please take

this product to the appropriate collection point. If you are

unsure of where this is contact your local authority.

Improper disposal may be harmful to the environment.

Disposal of electrical & electronic equipment Do not

dispose of this product with household waste. For the

proper treatment, recovery and recycling please take this

product to the appropriate collection point. If you are

unsure of where this is contact your local authority.

Improper disposal may be harmful to the environment.

OUR GUARANTEE

Your watch is guaranteed for 12 months from the date of purchase

against any faults arising from defective materials or manufacture.

Damage caused through careless handling, misuse or in transit is

expressly excluded. Should this watch fail within 12 months please

return it in the first instance to your retailer.

If you have any queries, problems or do not understand any

part of these instructions please contact:

Customer Help Line 01908 449208 or Local 0845 1207208

Mon – Fri 9am-4.30pm

e-mail for service: service@acctim.com or visit www.acctim.com

Battery Change Service

Acctim can offer you a battery change service for a fee of £10.00.

Should you want to take up this offer then please send your watch

along with your cheque for £10.00 payable to Acctim Limited to:

Watch Department, Acctim Limited, Acctim House,

Jenna Way, Newport Pagnell, Buckinghamshire, MK16 9QJ

8.Forced Synchronizaton and halt Synchronization

If you want the watch to attempt synchronization, you can force the

watch to do so by pressing the hidden pusher button ( D) for 5

seconds. This will activate synchronization. The bottom second

hands will point to RX. If the watch is in synchronization mode then

press the hidden pusher will halt the

synchronization .

9.Manual setting for Non Radio Controlled setting

If your location cannot receive Radio Controlled signal, you can

simply pull out the crown and push back the crown. The RCC function

of the watch will be eliminated. To start the RCC function, please

follow the Watch Hand Calibration for RCC function

button ( D) for 5 seconds

5 Seconds 5 Seconds

Acctim 60002 Operating instructions

Brand: Acctim

Model: 60002

Category: Watches

Type: Operating instructions

Acctim 60002

The Acctim 60002 is a solar-powered radio-controlled chronometer watch that combines precise timekeeping with advanced features for convenience and functionality.

Atomic Radio Control: Synchronizes with atomic clocks in Germany or the UK for unmatched accuracy, automatically adjusting for daylight saving time and standard time.
Solar Power: Charges through sunlight or indoor light, eliminating the need for frequent battery replacements.
Battery Indicator: Alerts you when the battery is low, ensuring uninterrupted operation.
Stopwatch Function: Measures time up to 60 minutes in seconds, perfect for sports, cooking, and other timing tasks.

Download PDF

report

Acctim 60002 Operating instructions

Acctim 60002 Operating instructions

Other documents