Eurotherm Mini8 Owner's manual

Hello! I am an AI chatbot trained to assist you with the Eurotherm Mini8 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Mini8 Controller Addendum 1

Part No HA029400 Issue 1.0 Aug-06 A-1

A. Addendum to Mini8 Controller V2.10

iTools Update Required

Please note – V2.10 is not fully supported by V6.44 Eurotherm iTools. An upgrade is

therefore required to use this version of the Mini8 controller. The files that are required can

be found on the CD provided.

To perform the upgrade after V6.44 iTools has been installed

1. Copy the V2.10 IDM and the V2.10 Help file (Located on the CD in the Software,

Comms Support, iTools section) to the C:\Program Files\Eurotherm\iTools\Devices

directory on the PC where iTools is installed.

2. On the PC select Start Æ All Programs Æ Eurotherm Æ iTools Advanced Æ IDM

manager if the PC is running Windows XP or Start Æ Programs Æ Eurotherm Æ

iTools Advanced Æ IDM manager if the PC is running Windows 2000 or NT.

3. When the program starts Click on the “Install New IDM” button, browse for the file

named ID_MINI8_V2.10.exe, select it and press the open button.

4. You will be asked if you would like to copy this file to another location, this is not

required since you have already saved the file in the correct location. Click No.

5. Installation is now complete.

Addendum 1 Mini8 Controller

A-2 Part No HA029400/1 (CN22645) Aug-06