B-Smart-Lock Keypad II | August 2018 01 - AN/ DSW | English |3
Dimensions 68,9 x 68,9 x 24 mm
Battery lithium battery 3V, CR123A
Service life:
45.000 locking cycles
Permissible temperature 0°– 40°C
(no formation of condensation)
Protection class IP 54
No. of possible codes 999.999
Code length 4 or 6 digits
Programming Freely selectable PIN
Fixed assigned PIN
Material Casing: plastic (RoHs proved)
Keypad: silicon
Keypad core: Zamak (zinc alumi-
nium)
Color grey or user specic
Locking direction L, R, LAD
Lock attachment raised countersunk screw
5 x 16, Torx 20
Latch plastic bolt
Technical specications
Functional description
Master code
The master code starts o any programming process an can
re-enable a lock anytime. In Freely selectable PIN mode, the
PIN used to close is deleted once the master code has been
entered.
Freely selectable PIN mode
In this mode, the user can enter any PIN.The user must rst
close the door. The user then enters a PIN of choice and enga-
ges the lock. The PIN entered is valid until the lock is opened
with the same PIN.
Fixed assigned PIN mode
In this mode, the PIN is stored in the lock. The lock only enga-
ges or disengages when the stored PIN is entered. Up to 50
PINs can be stored simultaneously. Each stored PIN can open
the lock, even it has been locked with a dierent PIN.
LED-locking status indicator
A red ash every second in the locking indicator indicates that
the lockis engaged. When open, the LED does not ash. This
function is optional and can be turned on or o as desired.
Code reenter
The verication code can only be used in Freely selectable PIN
mode. If a PIN is entered to engage the lock, it must be input
again, when the green LED ashes for a short time to conrm.
Only then does the lock actually engage. Simply enter the code
again to open.
Battery warning
The low battery warning is given in two stages. If the battery
capacity drops below the rst level, the LED lights up red for
three seconds after a PIN is entered. If the capacity falls to a
critical level, the lock cannot be engaged at all and can only
opened with the master code.
Note: we recommend replacing the battery as soon as the red LED
gives the rst warning.
Important information
Each step of the conguration is conrmed as completed
with a double ash of the LED. It is absolutely imperativ
to only begin the next step of the conguration after this
ashing signal.
If you switch from one mode to the other (Freely selectable
PIN Fixed assigned PIN; Fixed assigned PIN Freely
selectable PIN), all other functions are reset to the factory
settings.
Caution: This does not apply to the master code.
If the conguration step is completed incorrectly, the lock
signals this with 8 consecutive ashes of the LED.
Caution: the lock is disabled for 45 seconds after 3 wrong inputs. A
red ash every second indicates that the lock is currently disabled.
This disablement can be terminated early by entering the master
code.
The master code must always be entered as follows:
√ √ 1 master code √ e. g. √ √ 1 934 716 √