SR-G01 LEAFLET
40673612 1PD
*40673612- 01*
Notice: For G-70 Version 1.05 Users
Please read the following before updating your G-70.
If your G-70 currently uses software version 1.05, you will be asked to calibrate several settings after installing OS2.
* Please DO NOT turn off the power until you complete this calibration setting.
* Make sure that you correctly complete this setting, before moving to the next step.
1.
The G-70’s display shows the following message:
Move the BENDER/MODULATION lever left or right once, then let it return to the central position,
press the ASSIGN SW 1 button.
2.
The display shows the following message:
Move the BENDER/MODULATION lever to the far left and hold, press the ASSIGN SW 1 button.
3.
The display shows the following message:
Move the BENDER/MODULATION lever to the far right and hold, press the ASSIGN SW 1 button.
4.
The display shows the following message:
Release the BENDER/MODULATION lever so that it returns to the central position, press the ASSIGN SW 1 button.
5.
The display shows the following message:
Push the BENDER/MODULATION lever all the way towards the back of the G-70 and hold,
press the ASSIGN SW 1 button.
The G-70 exits the calibration routine and returns to the main menu.
6.
Power Off and Power On again, and you can move on to the next updating procedure.
Copyright © 2005 Roland Corporation.
All rights reserved. No part of this publication may be reproduced in
any form without the written permission of ROLAND CORPORATION.
** BENDER CALIBRATION **
Calibrating the CENTER POSITION:
Release the Pitch Bend lever, Press ASSIGN SW 1
** BENDER CALIBRATION **
Calibrating the HARD LEFT POSITION:
Move Pitch Bend lever to the left and press ASSIGN SW 1
** BENDER CALIBRATION **
Calibrating the HARD RIGHT POSITION:
Move Pitch Bend lever to the right and press ASSIGN SW 1
** MODUL CALIBRATION **
Release the Modulation lever
Press the ASSIGN SW 1
** MODUL CALIBRATION **
Press the Modulation lever to the back of the G-70
and press ASSIGN SW 1
SR-G01_l_e 1 ページ ２００５年１０月１９日 水曜日 午後５時３２分
/