Nomastyl SAMPLE_TL_GP_AT Operating instructions

How to Miter Nomastyl Crown Moulding Flat

To miter your corners ﬂat, you must use

two angled cuts - a bevel, and a miter.

For 90° Inside and Outside Corners

-Bevel at 30°

-Miter at 35.26°

Tips:

•

Note that the bevel angle will not change. You will rotate the miter and

flip the molding to make the two different cuts.

•

If your corners are not 90°, then you will have to adjust your angles.

When your crown proﬁle is too large to cut in position, it is recommended to cut your molding lying ﬂat with

a compound miter saw. Your saw only needs to bevel one direction.

Saw Fence

Outside Left Piece

Inside Right Piece

Saw Fence

Inside Left Piece

Outside Right Piece

Swing miter to the left

Wall Side to

the Fence

Ceiling

Side to the

Fence

Swing miter to the right

Bevel is set at 30° for both cuts

Bevel

Miter

Saw Fence

Download PDF