How to Miter Nomastyl Crown Moulding Flat
To miter your corners flat, you must use
two angled cuts - a bevel, and a miter.
For 90° Inside and Outside Corners
-Bevel at 30°
-Miter at 35.26°
Tips:
•
Note that the bevel angle will not change. You will rotate the miter and
flip the molding to make the two different cuts.
•
If your corners are not 90°, then you will have to adjust your angles.
When your crown profile is too large to cut in position, it is recommended to cut your molding lying flat with
a compound miter saw. Your saw only needs to bevel one direction.
Saw Fence
Outside Left Piece
Inside Right Piece
Saw Fence
Inside Left Piece
Outside Right Piece
Swing miter to the left
Wall Side to
the Fence
Ceiling
Side to the
Fence
Swing miter to the right
Bevel is set at 30° for both cuts
Bevel
Miter
Saw Fence
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI