2. Episode
  3. KIT-ECS-650-PND6-BLK

Episode KIT-ECS-650-PND6-BLK, KIT-ECS-650-PND4-BLK, KIT-ECS-650-PND4-WHT, KIT-ECS-650-PND6-WHT Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Episode KIT-ECS-650-PND6-BLK Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
© 2014 Episode
®
pg. 1
ECS-650-PND Owner’s Manual
WELCOME TO EPISODE
®
Thank you for purchasing a great product from Episode
®
,
one of the best sounding speaker lines available today.
We appreciate your purchase and are committed to
providing the highest quality products possible.
The ECS-650-PND series speaker line is a superb
choice for 70V/100V music distributed-line systems, and
can even be set to bypass the transformer if you need an
8 ohm speaker in a pinch.
KIT-ECS-650-PND4-BLK | KIT-ECS-650-PND4-WHT | KIT-ECS-650-PND6-BLK | KIT-ECS-650-PND6-WHT
OWNER’S MANUAL
Episode
®
Commercial 650 Series Pendant Speaker
• (1)ECS-650-PND4orECS-650-PND6Loudspeaker
• (2)Hanginghardwarekits
PACKAGE CONTENTS
• #2PhillipsScrewdriver
• SmallFlatheadScrewdriver
• WireStrippers
TOOLS REQUIRED
TheinstallationmethodsshouldbeinaccordancewiththeapplicablesectionoftheNationalElectricalCode,ANSI/
NFPA70,and/ortheNational FireAlarm Code,ANSI/NFPA 72, as applicable.Thewiringmethodandcompartment
shouldnotinterferewiththeoperationofthespeaker.
IMPORTANT INSTRUCTIONS AND CONSIDERATIONS FOR INSTALLATION
Clamp
Speaker Wire
Jack
Pendant Speaker
TapSwitch
Jack
Hanger
TapLocation
Screw-terminalconnector
Cable
Cable
withclip
StowAway
Handle
SecureAnchor
Point
SPEAKER WIRING
Overview
Ina70Vor100Vsystem,aspeakerwireisrunfromtheamplierlocationtotherstspeakerlocation.A“loopout”isrun
fromtherstspeakertothesecondspeaker,thesecondspeakertothethirdspeaker,etc.In8ohm(LowImpedance)
applications,aseparatespeakerwiremustberunfromtheampliertoeachspeakerlocation.
Recommended Wiring
• 70V/100Vapplications:18AWG,stranded,2conductorcable.
• 8ohm(LowImpedance)applications:16or14AWG,stranded,2conductorcable.
pg. 2
ECS-650-PND Owner’s Manual
SPEAKER INSTALLATION
General Guidelines
• Keepspeakersabout2feetawayfromcornersandothersurfacesthatmightinterferewithorreectsound,suchas
tall furniture.
• Forroomslessthan300squarefeet,twospeakersshouldsufce.Thefurtheraparttheyare,thebetterthesoundwill
be.However,keepthedistanceatamaximumof8-10feettoavoida“hole”inthemiddle.
• Forroomslargerthan300square feet, use 3ormorespeakers.Staggerthem across the space foridealsound
dispersion
1. Unpack speaker and
hanginghardware.Usethe
stowawayhandleforeasy
handling and transporting
of the speaker.
4. Threadhangingcable
throughtheclampasshown.
7. Attachthecablebysecuring
ittothe3-holehangeras
shown.Useincludedsafety
cablewhenrequired.
3. Connectsignalwiretoeither
ofthe(+)and(-)slotsonthe
screw-terminalconnector.
Ensure correct polarity and
tighten unused terminal
screws.Emptyslotscanbe
used as speaker loop-outs.
Refer to Speaker Wiring section
on Pg. 1 for more information.
WARNING:Donotusethe
stowawayhandleforhanging
thespeaker.Usethe3-hole
conguredhangertosuspend
the speaker.
WARNING:Donotsetthe
speaker for 8 ohm operation if
usinga70Vor100Vamplier.
This could cause permanent
damage to the speaker or
amplier.
6. Threadcableend(s)
throughclampasshown.
Adjustspeakerheightwith
the clamp.
9. Secure cables and
speakerwire.
2. Selectthedesiredtap
setting.
5. Attachthehangingcable
by securing it to structure
asshown.
8. Plugscrew-terminal
connectorintojackonrear
of speaker.
© 2014 Episode
®
pg. 3
ECS-650-PND Owner’s Manual
ECS-650-PND4
Woofer: 4”Polypropylene
Tweeter: 1”SilkDome
Power Handling: 40WattsRMS(@8Ω)
Nominal Impedance: 8 Ohms
Tap Settings:
-70V:3.75w,7.5w,15w,30w
-100V:7.5w,15w,30w
-8ΩBypass
Frequency Response (-6dB): 65Hz-20KHz
Sensitivity -2.83 V / 1 Meter: 84dB
Crossover Frequency: 3.3kHz
Weight: 4.5lbs.each
Grille Type: PowderCoatedPerforated
ECS-650-PND6
Woofer: 6½”Polypropylene
Tweeter: 1”SilkDome
Power Handling: 60WattsRMS(@8Ω)
Nominal Impedance: 8 Ohms
Tap Settings:
-70V:7.5w,15w,30w,60w
-100V:15w,30w,65w
-8ΩBypass
Frequency Response (-6dB): 60Hz-20KHz
Sensitivity -2.83 V / 1 Meter: 87dB
Crossover Frequency: 2.8kHz
Weight: 5.8 lbs. each
Grille Type: PowderCoatedPerforated
SPECIFICATIONS
pg. 4
ECS-650-PND Owner’s Manual
TROUBLESHOOTING
CONTACTING TECHNICAL SUPPORT
WARRANTY
Episode
®
speakersaredesignedtofunctiontrouble-free.Most problems that occur are duetosimpleissues.Ifyou
havetrouble,pleasecheckthelistofsimplexesbelow.Iftheproblempersists,contactEpisode®CustomerService
at1.866.838.5052
Phone:(866)838-5052
Email: Techsupport@snapav.com
140127-1750
©2014Episode
®
Limited Lifetime Warranty
Episode
®
PendantSpeakershaveaLifetimeLimitedWarranty.Thiswarrantyincludesparts
andlaborrepairsonallcomponentsfoundtobedefectiveinmaterialorworkmanshipunder
normalconditionsofuse.Thiswarrantyshallnotapplytoproductswhichhavebeenabused,
modied or disassembled. Products to be repaired under this warranty must be returned
to SnapAV or a designated service center with prior notication and an assigned return
authorizationnumber(RA).
No Sound
• Verifythatthereisaudiocomingfromthesourceselected.Selectanothersourceifnecessary.
• Ensurethattheaudiosourceisturnedonandconnectedproperly.
Lifetime
/