Episode KIT-ECS-650-PND4-BLK Owner's manual

Brand: Episode

Model: KIT-ECS-650-PND4-BLK

Type: Owner's manual

This manual is also suitable for

pg. 1

ECS-650-PND Owner’s Manual

WELCOME TO EPISODE

Thank you for purchasing a great product from Episode

one of the best sounding speaker lines available today.

We appreciate your purchase and are committed to

providing the highest quality products possible.

The ECS-650-PND series speaker line is a superb

choice for 70V/100V music distributed-line systems, and

can even be set to bypass the transformer if you need an

8 ohm speaker in a pinch.

KIT-ECS-650-PND4-BLK | KIT-ECS-650-PND4-WHT | KIT-ECS-650-PND6-BLK | KIT-ECS-650-PND6-WHT

OWNER’S MANUAL

Episode

Commercial 650 Series Pendant Speaker

• (1)ECS-650-PND4orECS-650-PND6Loudspeaker

• (2)Hanginghardwarekits

PACKAGE CONTENTS

• #2PhillipsScrewdriver

• SmallFlatheadScrewdriver

• WireStrippers

TOOLS REQUIRED

TheinstallationmethodsshouldbeinaccordancewiththeapplicablesectionoftheNationalElectricalCode,ANSI/

NFPA70,and/ortheNational FireAlarm Code,ANSI/NFPA 72, as applicable.Thewiringmethodandcompartment

shouldnotinterferewiththeoperationofthespeaker.

IMPORTANT INSTRUCTIONS AND CONSIDERATIONS FOR INSTALLATION

Clamp

Speaker Wire

Jack

Pendant Speaker

TapSwitch

Jack

Hanger

TapLocation

Screw-terminalconnector

Cable

withclip

StowAway

Handle

SecureAnchor

Point

SPEAKER WIRING

Overview

Ina70Vor100Vsystem,aspeakerwireisrunfromtheamplierlocationtotherstspeakerlocation.A“loopout”isrun

fromtherstspeakertothesecondspeaker,thesecondspeakertothethirdspeaker,etc.In8ohm(LowImpedance)

applications,aseparatespeakerwiremustberunfromtheampliertoeachspeakerlocation.

Recommended Wiring

• 70V/100Vapplications:18AWG,stranded,2conductorcable.

• 8ohm(LowImpedance)applications:16or14AWG,stranded,2conductorcable.

pg. 2

ECS-650-PND Owner’s Manual

SPEAKER INSTALLATION

General Guidelines

• Keepspeakersabout2feetawayfromcornersandothersurfacesthatmightinterferewithorreectsound,suchas

tall furniture.

• Forroomslessthan300squarefeet,twospeakersshouldsufce.Thefurtheraparttheyare,thebetterthesoundwill

be.However,keepthedistanceatamaximumof8-10feettoavoida“hole”inthemiddle.

• Forroomslargerthan300square feet, use 3ormorespeakers.Staggerthem across the space foridealsound

dispersion

1. Unpack speaker and

hanginghardware.Usethe

stowawayhandleforeasy

handling and transporting

of the speaker.

4. Threadhangingcable

throughtheclampasshown.

7. Attachthecablebysecuring

ittothe3-holehangeras

shown.Useincludedsafety

cablewhenrequired.

3. Connectsignalwiretoeither

ofthe(+)and(-)slotsonthe

screw-terminalconnector.

Ensure correct polarity and

tighten unused terminal

screws.Emptyslotscanbe

used as speaker loop-outs.

Refer to Speaker Wiring section

on Pg. 1 for more information.

WARNING:Donotusethe

stowawayhandleforhanging

thespeaker.Usethe3-hole

conguredhangertosuspend

the speaker.

WARNING:Donotsetthe

speaker for 8 ohm operation if

usinga70Vor100Vamplier.

This could cause permanent

damage to the speaker or

amplier.

6. Threadcableend(s)

throughclampasshown.

Adjustspeakerheightwith

the clamp.

9. Secure cables and

speakerwire.

2. Selectthedesiredtap

setting.

5. Attachthehangingcable

by securing it to structure

asshown.

8. Plugscrew-terminal

connectorintojackonrear

of speaker.

pg. 3

ECS-650-PND Owner’s Manual

ECS-650-PND4

Woofer: 4”Polypropylene

Tweeter: 1”SilkDome

Power Handling: 40WattsRMS(@8Ω)

Nominal Impedance: 8 Ohms

Tap Settings:

-70V:3.75w,7.5w,15w,30w

-100V:7.5w,15w,30w

-8ΩBypass

Frequency Response (-6dB): 65Hz-20KHz

Sensitivity -2.83 V / 1 Meter: 84dB

Crossover Frequency: 3.3kHz

Weight: 4.5lbs.each

Grille Type: PowderCoatedPerforated

ECS-650-PND6

Woofer: 6½”Polypropylene

Tweeter: 1”SilkDome

Power Handling: 60WattsRMS(@8Ω)

Nominal Impedance: 8 Ohms

Tap Settings:

-70V:7.5w,15w,30w,60w

-100V:15w,30w,65w

-8ΩBypass

Frequency Response (-6dB): 60Hz-20KHz

Sensitivity -2.83 V / 1 Meter: 87dB

Crossover Frequency: 2.8kHz

Weight: 5.8 lbs. each

Grille Type: PowderCoatedPerforated

SPECIFICATIONS

pg. 4

ECS-650-PND Owner’s Manual

TROUBLESHOOTING

CONTACTING TECHNICAL SUPPORT

WARRANTY

Episode

speakersaredesignedtofunctiontrouble-free.Most problems that occur are duetosimpleissues.Ifyou

havetrouble,pleasecheckthelistofsimplexesbelow.Iftheproblempersists,contactEpisode®CustomerService

at1.866.838.5052

 Phone:(866)838-5052

 Email: Techsupport@snapav.com

140127-1750

©2014Episode

Limited Lifetime Warranty

Episode

PendantSpeakershaveaLifetimeLimitedWarranty.Thiswarrantyincludesparts

andlaborrepairsonallcomponentsfoundtobedefectiveinmaterialorworkmanshipunder

normalconditionsofuse.Thiswarrantyshallnotapplytoproductswhichhavebeenabused,

modied or disassembled. Products to be repaired under this warranty must be returned

to SnapAV or a designated service center with prior notication and an assigned return

authorizationnumber(RA).

No Sound

• Verifythatthereisaudiocomingfromthesourceselected.Selectanothersourceifnecessary.

 • Ensurethattheaudiosourceisturnedonandconnectedproperly.

Lifetime

Episode KIT-ECS-650-PND4-BLK Owner's manual

Brand: Episode

Model: KIT-ECS-650-PND4-BLK

Type: Owner's manual

This manual is also suitable for

Download PDF

report

Episode KIT-ECS-650-PND4-BLK Owner's manual

This manual is also suitable for

Episode KIT-ECS-650-PND4-BLK Owner's manual

Related papers

Other documents