G306A

FW Murphy G306A, G3AD User manual

  • Hello! I am an AI chatbot trained to assist you with the FW Murphy G306A User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the purpose of the FW Murphy G3AD adapter panel?
    What is included in the G3AD adapter panel kit?
    What are the steps involved in installing the G3AD adapter panel?
    What is the maximum torque that can be applied to the KEPS nuts?
    What is the maximum torque that can be applied to the M-VIEW Touch mounting clips?
    Do I need to remove the mounting foot on the M-VIEW Touch mounting clips?
In order to consistently bring you the highest quality, full-featured products, we reserve the right to change our specifications and designs at any time.
FW MURPHY product names and the FW MURPHY logo are proprietary trademarks. This document, including textual matter and illustrations, is copyright
protected with all rights reserved. (c) 2021 FW MURPHY. A copy of our typical warranty may be viewed or printed by going to www.fwmurphy.com/warranty.
sect. 50 2115398
rev. 2021/06/15
Model G3AD – G3 to M-VIEW® Touch Adapter Panels
1. Remove existing G3 HMI from panel.
2. Install new G3 to M-VIEW Touch adapter panel into existing G3 cutout using the supplied panel gasket.
3. Install new KEPS nuts (supplied) onto new panel and tighten evenly for uniform gasket compression.
Note: Tightening the KEPS nuts beyond a maximum of 17 inch-pounds (1.92 N-m) may cause damage to the front panel.
4. Install new M-VIEW Touch into adapter panel using the mounting clips supplied and tighten to 6.0 pound-force inch (96
ounce-force inch) evenly for uniform gasket compression.
Adapter Panel Dimensions
Catalog Subsection for Table of Contents
95026 Product Name for Catalog Table of Contents
Ordering Information
The model G3AD adapter panels provide the necessary hardware to install an M-VIEW® Touch into an existing cutout where
a G3 unit once resided. These panels are coated with a durable silver nish that match the powder coat used on the M-VIEW
Touch series HMI. Also included in the kit are the necessary KEPS nuts and panel gasket required to meet any NEMA 4X/IP66
(face only) application.
Mounting Procedure
Existing
G3 Unit
Replacement
M-VIEW Touch A B C D
G306A MV-7T 8.83 7.08 7.06 4.89
G310S MV-10T 12.83 9.50 10.197 7.931
G310S MV-12T 12.83 9.50 11.458 7.561
Model NO Description Part Number
G3AD
G306A to M-VIEW Touch
7 Cutout Adapter
00034621
G310S to M-VIEW Touch
10 Cutout Adapter
00034620
G310S to M-VIEW Touch
12 Cutout Adapter
00034622
* The mounting clips
may or may not need
the mounting foot
removed in certain
installations, depending
on how close the
M-VIEW Touch is to the
original G3 cut out.
/