Inbay 241321-56-1 Installation guide

Type
Installation guide

The Inbay 241321-56-1 is a wireless charging tray compatible with Audi A4 models B6 and B7 manufactured between 2000 and 2009. It offers 10W fast charging for smartphones that support Qi wireless charging technology. The device connects to a socket of the fuse holder box and comes with a detailed installation guide to ensure proper setup.

The Inbay 241321-56-1 is a wireless charging tray compatible with Audi A4 models B6 and B7 manufactured between 2000 and 2009. It offers 10W fast charging for smartphones that support Qi wireless charging technology. The device connects to a socket of the fuse holder box and comes with a detailed installation guide to ensure proper setup.

1
© 2020 · acv GmbH · Straßburger Allee 10-12 · 41812 Erkelenz www.inbay.systems
Sachgeße Installation unter Beachtung dieser Einbauanleitung erfor-
derlich. Achten Sie auf korrekte Anschlüsse. Verlegen Sie die Kabel so, dass
Sie weder geknickt, gequetscht oder beschädigt werden können. Sorgen
Sie dafür, dass sich die Kabel nicht in Gegenständen verfangen können.
Wir können keine Haftung für Schäden übernehmen, welche durch un-
sachgemäße Installation oder Nutzung verursacht wurden. Verwenden Sie
darum ausschließlich das mitgelieferte Montagematerial.
Technische Änderungen vorbehalten, alle Angaben ohne Gewähr.
Das „Qi“ Logo ist Warenzeichen des „Wireless Power Consortium“
An appropriate installation in observance of these operating instructions
is necessary. Please make sure the wiring is arranged so it is not bended
or crimped due to the risk of cable break. Make sure that all connections
are correct. Route the cable away from moving parts, do not allow the
cable to be entangled, pinched or damaged in any way.
We will not be liable for damage due to improper installation or utilization.
Use the specified accessory parts to prevent product failure.
Subject to technical modifications; no responsibility is accepted for the
accuracy of this information.
The “Qi” symbol is a trademark of the “Wireless Power Consortium”
EINBAUANLEITUNG
DINSTALLATION GUIDE
GB
www.inbay.systems
level of difficultySchwierigkeitsgrad
gering hoch low high
2021-10-26
Wireless Charging Tray
241321-56-1 | Power: 10W
Audi A4 B6 (8E) 11/2000 - 2006*
Audi A4 B7 (8E) 04/2002 - 03/2008*
* Nur für Fahrzeuge mit Single-DIN
* Only for vehicles with 1-DIN head unit
Anschluss an einem Steckplatz
des Sicherungskastens
Connects to a socket
of the fuse holder box
A
B
Audi A4 Limousine B6 (Typ 8E) 11/2000 - 2004*
Audi A4 Avant B6 (Typ 8E) 09/2001 - 11/2004*
Audi A4 Cabriolet B6 (Typ 8E) 04/2002 - 2006*
Audi A4 Limousine B7 (Typ 8E) 11/2004 - 09/2007*
Audi A4 Avant B7 (Typ 8E) 11/2004 - 03/2008*
Audi A4 Cabriolet B7 (Typ 8E) 01/2006 - 02/2009*
* Nur für Fahrzeuge mit Single-DIN
* Only for vehicles with 1-DIN head unit
2
www.inbay.systems
3
2x 8 mm
4
www.inbay.systems
5
8 mm
6
8 mm
8 mm
www.inbay.systems
7
8
15A
www.inbay.systems
9
10
(-) Masse / ground
8 mm
www.inbay.systems
11
12
www.inbay.systems
13
START
STOP
Orange LED
Orange LED
Orange LED blinkt*
Orange LED flashing*
*Erkennung von Fremdkörpern wie Münzen etc. (FOD)
Aus Sicherheitsgründen wird der Ladevorgang gestoppt.
* Detection of foreign objects such as coins etc. (FOD)
The charging process is stopped for safety reasons.
Grüne LED*
Green LED*
*Abhängig vom Smartphone
*Depends on Smartphone
100%
Einbauanleitung / Install Manual
14
CARD
xxxx xxxx xxx
xxxx xxxx xxx
ACHTUNG! Nach der Installation düfen keine Geräte/Verbraucher mit mehr als 5A / 60W
an der +12V Buchse betrieben werden, da sonst die Gefahr einer Überspannung besteht!
ATTENTION! After installation, devices/consumers with more than 5A / 60W shall not be
operated on the +12V socket. Otherwise a risk of overvoltage can occur!
+12V
5A / 60W max
!
INTEGRATED
FOREIGN OBJECT
DETECTION (FOD) !
IMPORTANT INFORMATION:
Please don‘t place any other objects such as coins,
credit cards etc. onto the INBAY surface. Especially
smartphones with attached ring stand holder must
not be used! - otherwise the integrated Foreign
Object Detection (FOD) will interrupt wireless
charging for safetey reasons.
WICHTIGE NFORMATION:
Bitte legen Sie keine anderen Gegenstände
wie z.B. Münzen, Kreditkarten etc. in die INBAY
Ablage. Insbesondere Smartphones mit
angebrachtem Ring Ständer dürfen nicht
verwendet werden - da ansonsten aus
Sicherheitsgründen der Ladevorgang durch die
integrierte Fremdteileerkennung (FOD) gestoppt
wird.
www.inbay.systems
15
MANUAL
WICHTIG! NACH DER INSTALLATION MUSS DIESE EINBAUANLEITUNG
IN DAS HANDSCHUHFACH DES KUNDENFAHRZEUGS GELEGT WERDEN.
IMPORTANT! AFTER INSTALLATION THE MANUAL HAS TO BE PLACED INTO
THE DASH BOARD OF THE CUSTOMER‘S CAR.
241321-56-1
Input Voltage 12V (DC)
Output Voltage 5V 9V
Output Current 1.1A 1.2A
Output Power 5W 10W
Einbauanleitung / Install Manual
16
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16

Inbay 241321-56-1 Installation guide

Type
Installation guide

The Inbay 241321-56-1 is a wireless charging tray compatible with Audi A4 models B6 and B7 manufactured between 2000 and 2009. It offers 10W fast charging for smartphones that support Qi wireless charging technology. The device connects to a socket of the fuse holder box and comes with a detailed installation guide to ensure proper setup.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages