Hifonics TPS10 User guide

  • Hello! I am an AI chatbot trained to assist you with the Hifonics TPS10 User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The wiring and connections should be secure and away
from any moving parts or extremely hot surfaces.
Wiring
Power - Will turn the unit on or off / Five second hold/ quick push will switch inputs.
Track BACKWARDS - Press to restart the current track or to back up to previous tracks.
Volume UP - Each press will increase the volume.
Volume DOWN - Each press will decrease the volume.
Track FORWARD - Press to advance to the next track.
Map Light / Illumination - Turn on Map Light, cycle through illumination settings.
PLAY / PAUSE - Press once to pause. Press again to play.
During unit power up, the blue LED on the bottom of the control panel will blink
indicating that it is in Bluetooth search mode.
During this process “THOR” should show up in your list of Bluetooth devices when the
search has connected with your device. When the connection is made the blue LED will
change to a solid color.
Once a device has been paired, the unit will reconnect at power up to that device
when in range.
To connect to a different device, the rst device will need to be disconnected.
When a phone call is received, the audio signal will mute but not disconnect.
To switch to 3.5mm press the power button quickly.
To switch back to BT press the power button again quickly.
Controls
Bluetooth Device Pairing
1
2
3
4
5
6
7
The pairing process can vary based on your particular device. Refer to the
operating instructions of your device. Below is the general process to connect.
Congratulations on your choice of Hifonics THOR Sound
Bars.This “Quick Start” Installation guide is meant to help you
complete a basic installation. For more detailed information
about the product, please visit our website at Hifonics.com
3.5mm AUX IN
AUDIO OUTPUT
Red - 12v Power
Orange - Ignition Switch Input
Black - Ground
Blue - Remote Out
Volume UP
Power
Track FORWARD
1
2Track BACKWARDS
Volume DOWN
Play/PauseMap Light/ Illumination
3
4
5
6 7
Operators Guide
HF THOR SBAR QSG 01 - rev1
THOR
TPS6/TPS10
Soundbars
Hifonics products are designed and engineered in the USA by
www.maxxsonics.com
Visit Hifonics.com
1981
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
/