3.System Operations
3.1. Handheld Microphone Transmitter
A. Put two AA batteries correctly into battery slot and press the
ON/OFF button to turn on. The display screen shows Battery
Level, Signal level and Frequency Spot.
! Do remember to take off the battery when finish using.
Because battery leakage will seriously damage the
microphone circuit which presentsserious safety hazards.
B.Frequency spot changing. Take off the shell of battery slot,
where you will find the frequency select button inside. The
frequency spot will change with each click (The receiver will
automatically match any frequency spot you change to when
it is on working status).
!Re-pairing in case you can’t get the microphones and
receiver connected, or you have 2 sets or above and mixed
up the microphones and corresponding receivers. Please re-
pair the microphones and receiver by the following steps:
1. Turn off the microphone and receiver
2. Keep pressing frequency select button and the ON/OFF
button at the same time until the display screen of
microphone flashes
3. Turn on the receiver. They pair successfully if the
indicator light on the bottom of receiver flashes
4.Press the frequency select button to lock the pairing
C.The battery level indicator on the screen will flash when
batteries are running low. You are suggested to replace
batteries with new ones for good performance.
!Do not tap on the microphone grille, as there is a sensitive
capsule inside to pick up sound.
