Emtek IN4-NO8DM Installation guide

Hello! I've reviewed the provided installation guide for the Single-Point Lock Dummy. This document outlines the steps for installing the dummy chassis, trim plate, and handle, along with the required tools. I'm ready to answer any questions you may have about installation process.
What tool is needed to tighten the rosette threaded ring?

What tool is used to tighten the set screw?

What does 'Plates and grips vary depending on style' mean?

Installation Guide - Single-Point Lock, Dummy

IN4-NO8DM REV. 21A 10-25-2021

1. Install Dummy Chassis

Tighten rosette

threaded ring with

tool provided

2. Install Trim Plate

3. Secure Handle

Plates and grips vary

depending on style

After interior grip is

installed, tighten set

screw with hex wrench

provided.