Page is loading ...
nsinon
INSTRUCTION MANUAL
MODEL:
C
L-
H001E
OIL FREE CONVECTOR HEATER
Contents
5
0800 422 274 2 Kensington.
Important Safety Instructions
Electrical Safety and Cord Handling
nsington. 3 AFTEALES SUPPORT
Important Safety Instructions (Cont.)
Usage Conditions and Restrictions
4 Kensington.
Important Safety Instructions (Cont.)
@RNING!
6 Kensington.
DANGER if swallowed!
WARNING: Do not use this heater if it has been dropped;
Do not use if there are visible signs of damage to the heater;
WARNING: Use this heater on a horizontal and stable surface.
WARNING: To reduce the risk of fire, keep textiles, curtains, or any other
flammable material a minimum distance of 1 m from the air outlet.
Product Overview
nsington. 7
Handle
Control panel
On/Off control switch
Remote Control Storage
Support
Feet
Heater
Body
•
A
ssem
b
l
y
1). After removing from the packaging,
turn the heater upside down and
gently place on a scratch free surface
on the floor.
2). Remove the two support feet from
the packaging along with the retaining
screws.
3). Position the feet so the inner holes
align with the holes in the heater and
use a screw driver to securely tighten
the screws in position.
4). Carefully invert the heater to the
correct orientation.
WARNING - Never operate without the support feet attached or upside down, this
may cause permanent damage or present a fire risk.
Product Overview (Cont.)
•Control panel
•First time use
P
M
nsington.
8
AFTEALES SUPPORT
Note: The battery is pre-fitted in the remote control however to avoid discharge during
shipping prior to first use, an insulator tab is fitted over the battery terminal. To activate
the battery, pull to remove the insulator tab located protruding from the battery housing.
•
R
emote
c
ontrol
Operating Instructions
Ensure the appliance is pl aced on a level, stable support surface clear of
surrounding obstacles. Locate the main on/off switch on the side of the body
and check this is in the off position. Plug the supply cord plug into a socket
outlet and switch on. Switch the main on/off switch to the on position and an
audible "beep-beep' noise will be heard. The appliance is now in the
standby mode.
In the standby mode, control buttons will not be active. Once the standby
button is pressed, the appliance will default to 2
3℃
Eco mode . Press this
key again to enter the standby state.
Press the standby button, then press the on/off control switch below the contr ol
panel.
0800 422 274
9
Kensington.
P
w
Press the power mode button, consecutive presses will cycle between Eco
mode, High Power, Medium Power, and Low Power, step through until the
desired setting is selected.
E
M
When Eco mode is selected (as above, use power mode button to step through
until this is set, the display panel will show "Eco". Under this mode, the heating
power will adjust automatically when the room temperature is approaching the
set temperature. Example: The heater is set to 25℃. When the room
temperature is less than 22℃, the heater will operate under High power. When
the room temperature rises to 23℃, the heater will switch to operate at Medium
power. When the room temperature rises to 24℃, the heater will switch to
operate under low ower. When the room temperature reaches the set
temperature 25℃, the heater will switch off automatically. When the room
temperature becomes less than the set temperature, the heater will switch on
again under Eco mode.
Operating Instructions (Cont.)
6.
T
ime
r
s
e
tt
ing
s
nsington. 1
0
No timing is activated on the initial switch on. Press this button to switch on
timer and then use the " +" or "-" buttons to select desired timer on period
from 0.
5
hr to 24 hr.
Auto Power On:
Note:This function should only be set if you require the heater to be
automatically turned on after a certain period of time . Activate under Stand-
by mode.
1. Press the on/off power switch to turn the appliance on. The stand-by
button and Timer buttons will illuminate. The appliance will be in Stand-by
mode.
2. Press the Timer button and the start hour digit (0.0) will blink.
3. Use the “+” and “-” buttons to set the heater operation time between 1
and 24 hours. 0.0-5.0 hours increase by 0.5 hour, 5.0-24 hours increase by
1 hour. This function will activate once the hour digit stops blinking. The
count down digits will show on the display and the timer symbol will keep
blinking un til set time is reached.
4. The heater will automatically turn on when the time runs out.
Remark: After the timer power on setting, you can make the power mode
and temperature settings so that the heater will turn on at the desired
temperature and power mode.
h
Press the thermostat button once, the display with blink. The thermostat
temperature can be set by using the "+" and "-" buttons to select a setting
between 10℃ and 30℃. An option for anti-frost at 5℃ is also available. When
the desired setting is selected and no buttons are pressed for 3 seconds, the
display with stop blinking and the selection will be saved. During operation, the
heater will maintain the set ambient temperature switching on and off
automatically to regulate.
Operating Instructions (Cont.)
11 Kensington.
1. When the heater is operating, press the timer button, the timer symbol will
illuminate on the control panel and the start hour (0.0) digit will blink.
2. Use the “+” and “-” buttons to set the heater operation time between 1 and
24 hours. 0.0-5.0 hours increase by 0.5 hour, 5.0-24 hours increase by 1 hour.
This function will activate once the hour digit stops blinking. The count down
digits will show on the display.
3. The heater will automatically turn off when the time runs out.
Note : When using timer modes, consideration should be given to the fact that
the heater may come on whilst unattended. Always follow the safety instructions
provided.
WARNING: When not in use, please switch off the appliance by way of the on/
off control switch on the side of the appliance or remove the mains plug from the
socket outlet. Do not leave the appliance in the standby mode when unattended.
6.
T
ime
r
s
e
tt
ing
s CONTINUED
Auto Power OFF:
Note:This function should only be set if you require the heater to be
automatically turned off after a certain period of time . Activate when
in operation mode.
Operating Instructions (Cont.)
RNING!
nsington.
12
DANGER if swallowed!
Use of Remote Control:
1 .
Ensure insulator tab has been removed from the battery compartment,
simply pull to remove (first time use only).
2.
During use, poin t remote towards infrared receiver (control panel).
Obstructions in the path will hinder the performance of the remote. Place
remote accordingly. Take care not to drop the remote. For convenient
storage the remote can be placed in the holder below the control panel.
3.
For battery replacement please refer to the diagram above, press the side
lever first, then pull the carriage holder out.
4.
Push the carriage holder/ battery back into the remote and ensure it locks
securely into place.
Note: For battery replacement, please be aware of the negative and
positive markings to ensure correct polarity for the battery.
Other Useful Information
Cleaning and maintenance
•
Your appliance must be switched OFF at the mains supply socket then
unplugged before proceeding with any cleaning and maintenance.
•
If there's excessive foreign matter or dust attached to the body or fins, the
performance will be affected. It is therefore recommended to dust the surfaces
once every other month.
•
Surface cleaning
1.
Cl ean the housing with a lightly damp cloth, a vacuum cleaner or a dusting
brush.
2.
Use ordinary detergents and soft-bristle brushes for cleaning. Do not wash
with corrosive detergents or solvents.
•
Never immerse the appliance in water!
•
Clean the air inlet and outlet grilles (top and bottom) regularly with a vacuum
cleaner.
•
If the appliance is not used for an extended period it must be protected from
exposure to excessive dust and dirt. Store in a dry place away from sunlight
and dirt.
Technical Specification
0800 422 274 1
3
Kensington.
•220-240V ~ 50Hz, 2000W, Class I
Other Useful Information (Cont.)
Safety features:
Compliance
This appliance has been fully tested and meets all requirements as set out by
standards AS/NZS 60335.1 and AS/NZS 60335.2.30.
Responsible Disposal
At the end of its working life, do not throw this appliance out with your
household rubbish. Electrical and electronic products contain substances that
can have a detrimental effect on the environment and human health
if disposed of inappropriately. Observe any local regulations regarding the
disposal of electrical consumer goods and dispose of it appropriately for
recycling. Contact your local authorities for advice on recycling facilities in your
area.
nsington. 1
4
•
Tip
-
over protection
The heater is fitted with a safety tip over switch to turn the appliance off
automatically in the event of it tipping over. Do not use on thick and long pile
carpets or uneven surfaces as the heater may not work, due the tip over switch
not being activated.
•
Overheat protection
The heater is protected with overheat protection that switches off the appliance
automatically in case of severe overheating.
I
n this case, unplug the appliance,
wait about 30 minutes for it to cool and remove any possible cause of overheating,
eg. something covering the heater.
1
5
Kensington.
/
