2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Hagerco
  6. 297B - Mounting Bracket

Hagerco 297B - Mounting Bracket Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Hagerco 297B - Mounting Bracket Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
297B Inline Mounting Bracket
INSTALLATION INSTRUCTIONS
I-TA01246
Rev 3, Rev Date: 8/21/2020 Page 1 of 1
TOOLS REQUIRED
The 297B Inline Bracket is used to mount parallel arm closers,
non-re rated vercal rod strikes, or any other sot applied hard-
ware when using the 297D Series Coordinator. The 297B bracket
mounts through the coordinator allowing for installaon on any
frame dimension regardless of the sot width.
Installaon Instrucons:
1. Mount the 297D Coordinang Device per instrucons.
2. Posion 297B bracket in desired locaon.
3. Locate and mark 297B mounng holes onto Coordinator.
Note: Do not drill in shaded areas highlighted in the drawing below.
Flip bracket around to avoid these areas if necessary
4. Drill 2 each, #10 pilot holes through coordinator and into the sot
5. Secure 297B bracket to 297D Coordinator by using 2 each
12-24 x 2” [50.8] thread forming screws.
6. Drill and tap 297B bracket for sot applied hardware
7. Install sot applied hardware with 4 each 1/4-20 x 1/2” [12.7]
FH screws.
Note: Do not use screws longer than 1/2” [12.7].
279B bracket can
mount over the Co-
ordinator’s mounng
hardware
Install sot
applied hard-
ware to 279B
bracket using
1/4-20 x 1/2”
screws
Dimensions in [] denotes millimeters
/