Hagerco 297B - Mounting Bracket Installation guide

Hagerco
Brand
Hagerco
Model
297B - Mounting Bracket
Category
Wall & ceiling mounts accessories
Type
Installation guide
297B Inline Mounting Bracket
INSTALLATION INSTRUCTIONS
I-TA01246
Rev 3, Rev Date: 8/21/2020 Page 1 of 1
TOOLS REQUIRED
The 297B Inline Bracket is used to mount parallel arm closers,
non-re rated vercal rod strikes, or any other sot applied hard-
ware when using the 297D Series Coordinator. The 297B bracket
mounts through the coordinator allowing for installaon on any
frame dimension regardless of the sot width.
Installaon Instrucons:
1. Mount the 297D Coordinang Device per instrucons.
2. Posion 297B bracket in desired locaon.
3. Locate and mark 297B mounng holes onto Coordinator.
Note: Do not drill in shaded areas highlighted in the drawing below.
Flip bracket around to avoid these areas if necessary
4. Drill 2 each, #10 pilot holes through coordinator and into the sot
5. Secure 297B bracket to 297D Coordinator by using 2 each
12-24 x 2” [50.8] thread forming screws.
6. Drill and tap 297B bracket for sot applied hardware
7. Install sot applied hardware with 4 each 1/4-20 x 1/2” [12.7]
FH screws.
Note: Do not use screws longer than 1/2” [12.7].
279B bracket can
mount over the Co-
ordinator’s mounng
hardware
Install sot
applied hard-
ware to 279B
bracket using
1/4-20 x 1/2”
screws
Dimensions in [] denotes millimeters
  • Page 1 1

Hagerco 297B - Mounting Bracket Installation guide

Hagerco
Brand
Hagerco
Model
297B - Mounting Bracket
Category
Wall & ceiling mounts accessories
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents