Earthquaker Devices AFTERNEATHV2 User guide

Brand: Earthquaker Devices

Model: AFTERNEATHV2

Type: User guide

© 2014 EarthQuaker Devices LLC. | www.earthquakerdevices.com

Hey scamp, welcome to your new Afterneath from EarthQuaker Devices brand effects pedals! The

Afterneath is an otherworldly reverberation machine that uses a swarm of short delays to create wild

and cavernous reverbs and scattered, short rhythmic delays with bizarre characteristics. The reverb

created is beyond massive and goes well beyond the territory of most reverb pedals. The controls

allow you to stretch, smudge, swell and even self-oscillate into messy ambient washes of sound. The

Length control adjusts the decay of the reverb; anything from shorter hall through endless plate style

back through to create an even deeper otherworldly dreamscape. The Drag control lets you pull

the reverb through time by slowing down or speeding up the reverb. The Diffuse knob adds control

wash of smooth reverb. The Dampen

control adjusts the tone of the reverb, both stinging bright tones and warmer swell. The end result is

tched-out orchestra pit warming up in a

canyon at the bottom of another canyon inside a well. The Afterneath is true bypass with an all digital

reverb engine, all analog dry signal path and hand made one at a time by real living human beans in

dimly lit Akron, Ohio.

Controls

Length: Controls the decay length of the reverb.

Diffuse: Adjusts the spread of the reverb. Sharper with more attack counter clockwise, more

ambient and washy as you turn it clockwise.

Dampen: Clockwise for brighter tones, counter clockwise for darker tones.

Drag: This digital reverb is made up of a bunch of short delays, this separates the delay lines

creating a stuttering, pingy effect. This is the coolest control on the Afterneath; we highly advise

slowly turning this while you let notes ring out for a cool warped speed effect. More delay as you

turn it counter clockwise, more reverb as you turn it clockwise.

Controls the regeneration of the reverb, turn clockwise for more wash and echos,

counterclockwise for less. This will self oscillate if turned up high.

Mix: Blends the wet signal into the dry. Though it does not actually go full wet, it will gradually

lower the clean level as you turn it clockwise and give the appearance of full wet.

Power

Any regulated 9 volt DC power supply with a negative 2.1mm center barrel intended for musical

instruments. Daisy chaining is not recommended but will not hurt the device. Current draw is

around 65ma.

Questions? Concerns?

Send an email to info@earthquakerdevices.com

See EarthQuakerDevices.com/info for warranty information.

1

Earthquaker Devices AFTERNEATHV2 User guide

Brand: Earthquaker Devices

Model: AFTERNEATHV2

Type: User guide

Related papers

Other documents