Redi Shade 3513752 Installation guide

Brand
Redi Shade
Model
3513752
Type
Installation guide

This manual is also suitable for

Included: Easy Lift Shade with Trimming Scale | Trimming Guide
Measure your window width in 3 locations. Use the
smallest measurement.
(Please note our patented cutting scale already takes
into account the clearance deduction for inside mount.)
1
2
Measure
Trim
3
Install & Operate
a) Peel to remove liner.
©2015 Redi Shade, Inc. www.redishade.com 072915
b) Press rmly across width of
shade to install.
c) Pull shade down to lower
and push up to raise.
A smooth kitchen knife with a 3.5” inch blade is recommended.
1) Remove bottom rail end caps.
2) Place cutting guide at exact desired width. (No clearance deduction needed; it’s already included).
3) Position the knife blade at an angle on the top of the shade at your exact measurement.
a) Press rmly cutting through rails and fabric with a rocking motion and constant pressure.
b) Trim each side of the shade to the same exact window measurement.
4) Replace end caps on bottom rail.
1
2
3
4
View the Easy Lift trimming and installation video at www.redishade/easy-lift.com.
Customer Service: 1-888-608-6611
Cleaning & Troubleshooting
Lightly dust or vacuum with upholstery attachment. For spot cleaning lightly blot with mild detergent and warm water.
The shade is not intended for dry cleaning, spot removers, strong detergent or full water immersion.
If your shade becomes unbalanced and hangs unevenly, open gently to full length to reset.
For other information or questions, please visit www.redishade.com/FAQ
  • Page 1 1

Redi Shade 3513752 Installation guide

Brand
Redi Shade
Model
3513752
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents