assembly instructions
1. Remove contents from box.
2. Place seat upside down on a flat surface so holes
are showing.
3. Align leg section A (the leg section that has the
concave area on the underside) with the holes in
seat. Place and tighten the two handscrews in the
outer holes, making sure to put on a metal washer.
Do not affix the middle handscrew.
4. Align leg section B (the leg section that has the con
cave area on the top side) with the holes in the seat.
Place and tighten the two outer holes using the
handscrews and washers.
5. Place the middle handscrew and tighten through the
two legs.
NOTE: Periodically check the handscrews to make sure
they remain tight as loosening may occur.
A
B
lifetime limited
warranty
Your Drive branded product is warrantied to be
free of defects in materials and workmanship for
the lifetime of the product for the original con-
sumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2014 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington, N.Y. 11050 USA Made in China
Rev.4.08.4.15
Weight capacity: 300 lbs (136 Kg)