OvisLink VESC0-SB User manual

Brand: OvisLink

Model: VESC0-SB

Type: User manual

Visbr Document

Page 1 of 3

Visbr Active Noise Canceling Headphones User Manual

Product Features

Charge Headphones Battery

For low battery a red light on the Visbr button will flash for 1 minute. Then unit will turn off.

Connect the headphones to the USB port of a powered ON computer or USB wall adaptor using the Micro-USB to USB cable.

Faulty power adapters might overheat the headphones or the USB port. If the adapter is defective please switch USB adapters.

Visbr Document

Page 2 of 3

Headphones include a 3 ft Micro-USB to USB cable, connect the headphones

to the USB port of a powered ON computer or USB power adaptor (not

included).

Noise Canceling Function

The Noise Canceling feature will electronically mute background noise. This feature eliminates constant noises such as

airplane engine sounds that are prolonged for long periods of time. Noisy disturbances that are not constant are not muted;

such as talking or TV sounds. It can be used with the Bluetooth or Aux In modes to enhance the quality of any music or audio

that is playing through the headphones.

Noise canceling mode will function even if the headphones are not powered ON. To conserve battery power, it is

recommended to power the headphones OFF if you want to use the Noise Canceling feature without playing audio.

1. To activate noise canceling, press the right side of the Main

Control button. A green LED light in the button will turn ON.

2. To deactivate noise canceling, press the right side of the Main

Control button again. The green LED light in the button will

turn OFF.

Connect with Bluetooth

After initial pairing; the unit will stay paired unless unpaired manually by the user, or erased due to a reset of the device. If your

device should become unpaired or disconnected you may turn the device on and keep the button pressed until headphones

indicate BLUETOOTH IS CONNECTING and then on your phone/tablet/computer you will find the indication Visbr-ESC0.

1. Press and hold the left side of the Main Control button for

approximately 4 seconds to power ON and begin pairing. LED lights in

the button will show blue when Bluetooth is activated.

2. When pairing, Visbr button will flash a red and blue light; remain

within 3 feet of the unit to optimize connection to pair.

Visbr Document

Page 3 of 3

Connect with Audio Cable

3’6” AUX 3.5mm cord included to connect directly to

phone/tablet’s headphones port. Connect one end of the cord

to your headphones and the other end to your phone/tablet.

Connect with Airplane Audio System

To connect to airplane’s Audio ports use Airplane adapter by

connecting the AUX 3.5mm cord to the adapter and then the

airplane’s arm rest where the Audio ports are located.

For more information, please contact Visbr at sale[email protected]om. If you are having trouble with the audio/microphone for your

headset, or you cannot hear a dial tone; please email us at sup[email protected]om.

OvisLink VESC0-SB User manual

OvisLink VESC0-SB User manual

OvisLink VESC0-SB User manual

Other documents