Visbr Document
Page 1 of 3
Visbr Active Noise Canceling Headphones User Manual
Product Features
Charge Headphones Battery
For low battery a red light on the Visbr button will flash for 1 minute. Then unit will turn off.
Connect the headphones to the USB port of a powered ON computer or USB wall adaptor using the Micro-USB to USB cable.
Faulty power adapters might overheat the headphones or the USB port. If the adapter is defective please switch USB adapters.
Visbr Document
Page 2 of 3
Headphones include a 3 ft Micro-USB to USB cable, connect the headphones
to the USB port of a powered ON computer or USB power adaptor (not
included).
Noise Canceling Function
The Noise Canceling feature will electronically mute background noise. This feature eliminates constant noises such as
airplane engine sounds that are prolonged for long periods of time. Noisy disturbances that are not constant are not muted;
such as talking or TV sounds. It can be used with the Bluetooth or Aux In modes to enhance the quality of any music or audio
that is playing through the headphones.
Noise canceling mode will function even if the headphones are not powered ON. To conserve battery power, it is
recommended to power the headphones OFF if you want to use the Noise Canceling feature without playing audio.
1. To activate noise canceling, press the right side of the Main
Control button. A green LED light in the button will turn ON.
2. To deactivate noise canceling, press the right side of the Main
Control button again. The green LED light in the button will
turn OFF.
Connect with Bluetooth
After initial pairing; the unit will stay paired unless unpaired manually by the user, or erased due to a reset of the device. If your
device should become unpaired or disconnected you may turn the device on and keep the button pressed until headphones
indicate BLUETOOTH IS CONNECTING and then on your phone/tablet/computer you will find the indication Visbr-ESC0.
1. Press and hold the left side of the Main Control button for
approximately 4 seconds to power ON and begin pairing. LED lights in
the button will show blue when Bluetooth is activated.
2. When pairing, Visbr button will flash a red and blue light; remain
within 3 feet of the unit to optimize connection to pair.
Visbr Document
Page 3 of 3
Connect with Audio Cable
3’6” AUX 3.5mm cord included to connect directly to
phone/tablet’s headphones port. Connect one end of the cord
to your headphones and the other end to your phone/tablet.
Connect with Airplane Audio System
To connect to airplane’s Audio ports use Airplane adapter by
connecting the AUX 3.5mm cord to the adapter and then the
airplane’s arm rest where the Audio ports are located.
For more information, please contact Visbr at sale[email protected]om. If you are having trouble with the audio/microphone for your
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
NAD HP70 Owner's manual
-
Insignia NS-AHBTOENC/NS-AHBTOENC-C Noise-Canceling Over-Ear Headphones Quick setup guide
-
Creative GH0250 User manual
-
-
Bowers & Wilkins PX7-SPCGREY User manual
-
Toshiba PDA03A-00100H User manual
-
-
August EP750 User manual
-
-
Lenovo ThinkPad Tablet 2 User manual