AireRyder LK55416BBZ-C User guide

AireRyder
Brand
AireRyder
Model
LK55416BBZ-C
Category
Household fans
Type
User guide

This manual is also suitable for

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless
additional support is provided for the fan.
LK55416 / LK55516 / LK55616 / LK55716
1. Remove the switch box cover from
the switch box of the fan by loosing
the three switch box screws.
2. Unscrew the center plug from the
switch box cover and discard it.
3. Attach nipple(-a) of the light kit to the
switch box cover, then secure it with a
washer and hex nut.
4. Pull out the wires from the switch box.
Make wire connections using the wire nuts:
---The smooth (marked) wire from the fixture to the black (or blue) wire from the switch
box.
---The ridged (unmarked) wire from the fixture to the white wire from the switch box.
Carefully put the wires back into the switch box.
5. Attach the switch box cover back to the switch box using the three switch box screws.
6. Carefully place the decorations onto the glass shades. Then attach the glass shades to the
glass holders and secure them with the set screws.
7. Install bulbs (included). See relamping label at socket area or packaging for maximum
allowed wattage.
8. Turn on the power at the main fuse or circuit breaker box. (You can control the light
with the pull chain.)
For Light Kit:
Center Plug
Smooth Wire
Wire Nut
Black or Blue Wire
Ridged Wire
White Wire
Switch Box
Motor
Hex Nut & Washer
Nipple(-a)
Switch Box Cover
Switch Box Screw
Fixture
Arm
Glass Holder
Set Screw
Glass Shade
Decoration
Pull Chain
Socket
Page 1 / 2
Bulb Type A15 Max.60W
(included)
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in
current limiting device to conserve energy. Please do not operate
it with lamps that together consume more than 190 watts. If the
fan light shut off shortly after it was switched on, it may be due to
excessive current demand. Turn off power to the fan and replace
the light bulbs with lower wattage bulbs. Powers up again by pull
chain or wall switch or remote control depend on what is installed
with the particular fan.
F A N C O
091230
Fixture Wire
Chain
Mounting Screw
Nipple(-b)
Fixture Grounding Wire
Collar
Top Loop
Canopy
Mounting Strap
Green Grounding Screw
Hex Nut
Wire Nut
Washer
Outlet Box
Nipple(-a)
Washer
Grounding Pad
Loop
Hex Nut
House Grounding Wire
Loop Lock
Loop Lock
Loop
1. Take out the loop, grounding pad and washer from
the hardware package for Mini Chandelier.
2. Adjust the hex nut on nipple(-a) to make a length of
1/2" from the top of nipple(-a) to the top of the hex
nut. (See Fig.1)
3. Attach a washer and the grounding pad to the hex
nut on nipple(-a), then secure them with the loop.
4. Choose the length of the chain you need, then
weave the fixture wire and the fixture grounding
wire through the chain. Then connect one end of
the chain with the loop by using one loop lock.
5. Secure the top loop to nipple(-b).
6. Thread the fixture wire and fixture grounding wire
through the collar, canopy, top loop, nipple(-b) and
mounting strap.
7. Connect the other end of the chain with the top loop
by using the other loop lock.
8. Pull out the outlet wires and the house grounding
wire from the outlet box. Make wire connections
using the wire nuts:
---The smooth wire (marked) from the fixture to the
black wire from the power source.
---The ridged wire (unmarked) from the fixture to
the white wire from the power source.
---Attach the fixture grounding wire to the mounting
strap with the green grounding screw. Then
connect it to the house grounding wire with a
wire nut.
Carefully put the wires back into the outlet box.
9. Attach the canopy to the mounting strap by inserting
the top loop, then secure it with the collar.
10. Repeat the steps 6~8 for Light Kit.
For Mini Chandelier: (See Fig.1 & Fig.2)
Fig.2
Fig.1
Mounting Parts for Mini Chandelier
Nipple(-a)
Fixture
1/2"
Page 2 / 2
F A N C O
091230
  • Page 1 1
  • Page 2 2

AireRyder LK55416BBZ-C User guide

AireRyder
Brand
AireRyder
Model
LK55416BBZ-C
Category
Household fans
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents